What are the safety precautions for JLG lift?
What are the safety precautions for JLG lift?
INTRODUCTION – MAINTENANCE SAFETY PRECAUTIONS 3120878– JLG Lift –a SECTION A. INTRODUCTION – MAINTENANCE SAFETY PRECAUTIONS A.A GENERAL This section contains the general safety precautions which must be observed during maintenance of the aerial platform.
Where to get replacement parts for a JLG?
If you ever need JLG replacement parts or accessories, you can visit our website by clicking here. Description: Both platform and ground modes are selected simultaneously. Check: Key switch function, Check wiring to key switch function.
What is the service and maintenance manual for JLG Industries?
Service and Maintenance Manual Models 1532E3 1932E3 2033E3 2046E3 2646E3 2658E3 3120878
What should voltage be on JLG aerial lift?
Description: The manual brake release switch was closed during power-up. Check: Check if brake release switch is obstructed or jammed. Description: Elevation angle sensor input voltage is outside the acceptable range of 0.10V – 4.50V.
If you ever need JLG replacement parts or accessories, you can visit our website by clicking here. Description: Both platform and ground modes are selected simultaneously. Check: Key switch function, Check wiring to key switch function.
What causes a JLG aerial lift to stop working?
Check: Recharge batteries or check for damaged batteries. Description: Drive, steer, and lift prevented. Check: The system module applied field current, but could regulate the desired current. The situation is caused by improper field wiring or a damaged motor.
Are there any problems with the JLG boom lift?
Well that’s alright because we’ve come up with a troubleshooting page for you, this one specifically for JLG boom lifts. Written below are some highly popular JLG boom lifts and their corresponding error codes, although not restricted to these models.
What should I look for on a JLG lift?
Description: The joystick signal is outside the acceptable range of 0.5V – 4.5V. Check: Center joystick and check to see if a power cycle will clear DTC. Description: The ground control box lift switch was closed up or down, during power up in ground mode. Check: Check if the lift switch is obstructed or jammed.
