How to check for oil leak in Bobcat 753?
How to check for oil leak in Bobcat 753?
Inspect compartment with good light looking for leak, but avoid allowing any stream of oil to spray your skin. Check the main loader control valve on right side and check the work equipment pump mounted on the end of the tandem drive pump.
Where is the boss @ system located on a bobcat?
The BOSS@ System uses a microprocessor, located behind the operator cab to: Monitor loader/engine functions Warn of system malfunctions Perform automatic shutdown under certain catastrophic conditions Store defect codes for later service access Control glow plug operation soss e
Where is the gushing fluid on the bobcat?
Welcome to HeavyEquipmentForums.com!! ALL NEW MEMBERS PLEASE READ THIS FIRST!!! Bobcat 753 “gushing” hydraulic fluid beneath seat on right hand side of machine. Discussion in ‘ Skid Steers ‘ started by CarpenterRick, Sep 8, 2011 . Machine was running great, has approx 1800 hrs.
How is diagnostic tool used in Bobcat service?
Diagnostic Tool is used by Bobcat Service Technicians to access defect codes/occurances and current status of loader functions. Information can also be printed. * Available on some models only. See your Bobcat dealer for details. Title Bobcat Operation Sensing System Literature — 1997
Inspect compartment with good light looking for leak, but avoid allowing any stream of oil to spray your skin. Check the main loader control valve on right side and check the work equipment pump mounted on the end of the tandem drive pump.
How much does it cost to rebuild a bobcat 753?
They have a cap on the ends, didn’t find the leak until i took the cap off. Bobcat charged about $100 to rebuild it out of the machine and said 4 to5 hours of labor on top of that if they took it out. With the cap off it will spray straight toward the back of the machine. Willie the 863 is gone/sold, now the 753 is left.
How to replace control valve on Bobcat loader?
On the wheel loaders, it’s a little easier because you can remove a side plate to access the front of the control valve easy. On the track machines, such as T190, the track frame gets in the way of working through side panel so all parts of the repair are done on the topside with cab raised.
Where is the hole in a Bobcat loader?
At the rear of that compartment is a hole in the belly of the machine. Place an oil drain pan under the hole to contain the oil that will drain from control valve while making repairs. Track machines have the hole in a different location.
