What are the torque specs for the top end of C 15?
What are the torque specs for the top end of C 15?
Reinstall the valve mechanism cover. Tighten the studs at Locations (3) , (4) , and (5) to a torque of 50 ± 5 N·m (37 ± 4 lb ft). Tighten the studs for an additional 45 ± 5 degrees. Tighten the stud at Location (2) to a torque of 65 ± 10 N·m (48 ± 7 lb ft). Refer to Specifications for more information. Install variable valve actuator (5) .
How is the torque of a cat MX measured?
The dimension is measured from the top of the unit injector to the machined ledge of the fuel injector body. Turn unit injector adjustment screw (2) clockwise until the correct height is obtained. Hold the adjustment screw in this position and tighten locknut (3) to a torque of 100 ± 10 N·m (74 ± 7 lb ft).
How much torque does an Acura D16A1 have?
Torque Specifications Make Liter CID Engine Model Year Rod Torque Main Torque Cylinder Head Bolt Torque ACURA 1.6 97 D16A1 86-89 23 FT/LBS 40 FT/LBS 22, 47 FT/LBS
Which is the correct torque for the jam nut?
Tighten jam nut (1). Refer to Specifications, “Variable Valve Actuators” for the proper torque for the jam nut. Turn the crankshaft clockwise by 360 degrees. This will position the No. 6 piston at the top center on the compression stroke. Install the timing bolt in the flywheel. Repeat Step 5 for the following cylinders: 3, 5 and 6.
Reinstall the valve mechanism cover. Tighten the studs at Locations (3) , (4) , and (5) to a torque of 50 ± 5 N·m (37 ± 4 lb ft). Tighten the studs for an additional 45 ± 5 degrees. Tighten the stud at Location (2) to a torque of 65 ± 10 N·m (48 ± 7 lb ft). Refer to Specifications for more information. Install variable valve actuator (5) .
How much torque does a SAE 5 socket head cap screw have?
CONVERSION TABLES Torque applifast.com Steel Grade SAE 5 SAE 8 Socket Head Cap Screws Property Class 8.8 10.9 12.9 Socket Head Cap Screw Torque in Pound Foot or (Pound Inch) Torque in Newton Meter – Nm Lubed means cleaned, dry bolts, lubricated with standard medium viscosity machine oil. Lubricate all contact areas of the bolts and washers.
Tighten jam nut (1). Refer to Specifications, “Variable Valve Actuators” for the proper torque for the jam nut. Turn the crankshaft clockwise by 360 degrees. This will position the No. 6 piston at the top center on the compression stroke. Install the timing bolt in the flywheel. Repeat Step 5 for the following cylinders: 3, 5 and 6.
What’s the best way to lubed a torque table?
Lubricate all contact areas of the bolts and washers. Lubricating the bolts is the suggested method. Lubed means cleaned, dry bolts, lubricated with standard medium viscosity machine oil. Lubricate all contact areas of the bolts and washers. Lubricating the bolts is the suggested method. Nom Dia-Pitch Nom Size x Pitch INCH BOLT TORQUE TABLE
