How do you remove a John Deere fuel pump?
How do you remove a John Deere fuel pump?
Slide the clamps on the fuel lines back, on each end of the fuel pump, with the needle nose pliers. Slide the fuel line off each end of the fuel pump. Remove the two 3/8-inch bolts holding the fuel pump to the engine block, slide the fuel pump off.
How to remove injection pump gear from John Deere?
Remove injection pump drive gear cover. Shown removed (on John Deere Application) 6. Remove injection pump drive gear cover (shown removed). Remove drive gear retaining nut and washer from end of pump shaft. Be careful not to let washer fall inside timing gear cover.
How to replace the fuel pump on a Kawasaki motor?
Pinch the hose clamps—using needle-nose pliers—on the fuel lines that are placed over the inlet and outlet barb on the fuel pump and slide the clamps back two inches. Remove the two bolts that hold the fuel pump against the engine with the 10 mm wrench. Remove the fuel pump, gaskets, insulator and push rod.
How do you replace a fuel pump on a car?
Place the fuel pump over the insulator and reinstall the bolts. Push the outlet and inlet fuel lines back onto the new fuel pump and slide the hose clamps back into position with the needle-nose pliers.
Slide the clamps on the fuel lines back, on each end of the fuel pump, with the needle nose pliers. Slide the fuel line off each end of the fuel pump. Remove the two 3/8-inch bolts holding the fuel pump to the engine block, slide the fuel pump off.
Pinch the hose clamps—using needle-nose pliers—on the fuel lines that are placed over the inlet and outlet barb on the fuel pump and slide the clamps back two inches. Remove the two bolts that hold the fuel pump against the engine with the 10 mm wrench. Remove the fuel pump, gaskets, insulator and push rod.
Place the fuel pump over the insulator and reinstall the bolts. Push the outlet and inlet fuel lines back onto the new fuel pump and slide the hose clamps back into position with the needle-nose pliers.
Where is the fuel pump on a lawn mower?
Park the lawnmower on a level surface and set the parking brake. Turn the ignition key to the “OFF” position. Open the hood of the tractor and locate the fuel pump on the left side of the engine, below the engine shroud. Turn the fuel valve to the “OFF” position.
