What are the torque specifications for a manual transmission overhaul?
What are the torque specifications for a manual transmission overhaul?
Torque Specifications / 22B-10MANUAL TRANSMISSION OVERHAUL – Special tools TRANSFER Items Nm {kgf m} Transfer cover mounting bolt 23 {2.4} Transmission-transfer mounting bolt 69 {7.0} SPECIAL TOOLS
What kind of bolts are in a Torx transmission?
Transmission to Engine Torx Bolts (M8) – 21Nm Transmission to Engine Torx Bolts (M10) – 42Nm Transmission to Engine Torx Bolts (M12) – 63Nm Transmission Rear Support to Body – 21Nm Torque Convertor to Driveplate (M10) – 49Nm Transmission Reinforcement Plate – 23Nm Fluid Filler Tube to Transmission Sump (3 HP 22) – 100 to 110Nm
How big is the output shaft flange nut?
Output Shaft Flange Nut (Getrag Transmission) – 170Nm then loosen completely and then tighten to 120Nm Transmission to Engine Hex Bolts (M8) – 22 to 27Nm Transmission to Engine Hex Bolts (M10) – 47 to 51Nm Transmission to Engine Hex Bolts (M12) – 66 to 82Nm Transmission to Engine Torx Bolts (M8) – 20 to 24Nm
What are the torque settings for a Torx head?
Cylinder Head Bolts M20 (Hex-Head) – 40Nm, wait 15mins & tighten to 60Nm then another 25° with engine at normal working temperature. Cylinder Head Bolts M20 (Torx Head) – 30Nm, wait 15mins & tighten additional 90° then another 90° with engine at normal working temperature.
Torque Specifications / 22B-10MANUAL TRANSMISSION OVERHAUL – Special tools TRANSFER Items Nm {kgf m} Transfer cover mounting bolt 23 {2.4} Transmission-transfer mounting bolt 69 {7.0} SPECIAL TOOLS
How much torque does a 5 speed transmission have?
Preload adjustment of thrust bearing Starting torque: 0.3 0.8 N·m (0.03 0.08 kgf-m, 0.2 0.6 ft-lb) 5. REVERSE IDLER GEAR Adjustment of reverse idler gear position Reverse idler gear to transmission case (LH) wall clearance: 6.0 7.5 mm (0.236 0.295 in) After installing a suitable reverse shifter lever, ad- just the clearance using washers.
How much torque does a 5MT pinion have?
Bolt No. Bolt size mm Tightening torque: N·m (kgf-m, ft-lb) (5) (15) 8 25 (2.5, 18.4) (1) (4) (16) (17) 10 39 (4.0, 28.9) MT-00003 (9) (5) (7) (16) (17) (3) (4) (11) (1) (2) (10) (6) (8) (12) (14) (13) (15) 5MT-8 General Description MANUAL TRANSMISSION AND DIFFERENTIAL 2. DRIVE PINION ASSEMBLY
What should the clearance be on a transmission disc?
Soak the clutch discs in transmission fluid before installation as fluid affects clutch thickness and clearances. Load the pressure plate after all frictions and steels are in. Clearances should be .050 to .089 inch for V-8s and .040 to .071 inch for V-6s between the pressure plate and the first disc.
