How do you bleed a fuel system on a Massey Ferguson 135?
How do you bleed a fuel system on a Massey Ferguson 135?
Open the fuel petcock until fuel fills the fuel filter housings. Move the lever on the side of the fuel pump mounted to the engine block back and forth by hand until fuel begins to leak out of the bottoms of the fuel filter housings. Tighten the bleed screws on both the filter housings by hand.
How do I Bleed fuel in a Massey Ferguson?
240s massey ferguson 3 cylinder how do I bleed fuel injections. Let me go outside and retrieve this give me 2 minutes if Question about Massy Ferguson 265 diesel tractor.
What to do if your diesel fuel line is bleeding air?
Here are the steps to take in bleeding air from a diesel fuel system: 1. Turn off fuel valve. 2. Clean outside of filter housing. 3. Install new filter element and new gaskets. A little oil on the gasket will aid a tight seal. 4. I’d suggest that you fill a spin-on filter with clean fuel before installation. 5.
When to close bleed plugs on diesel engine?
Close bleed plugs after all air is removed from the fuel tank, filters, settlement bulb, and fuel pump (only one at a time working through all bleed screws beginning closest to tank and ending at nozzles if necessary). 10. Try the engine; if it doesn’t start or runs poorly, you may have to bleed the injection
What kind of diesel does a Massey Ferguson have?
DO NOT TRY TO ANSWER UNLESS TECH HAS YEARS OF DIRECT EXPERTISE WITH PERKINS DIESEL TYPE AD3.152. I have a 1983 Massey Ferguson MF-240, Perkins diesel type AD3.152, about 1400 hours.
240s massey ferguson 3 cylinder how do I bleed fuel injections. Let me go outside and retrieve this give me 2 minutes if Question about Massy Ferguson 265 diesel tractor.
How to bleed the fuel system and filter?
Unfortunately it is not feasible to fill the new element with fuel so the air will have to be evacuated and replaced with fuel as part of the fuel bleeding process . This will be done with the hand primer pump. PURGING THE AIR WITH THE HAND PRIMER PUMP : Don’t be stingy when venting air and/or a mixture of air and fuel. The fuel system must be
Why is my Massey 65 not turning right?
Checked tank again – alot of air bubbles and down to bottom of filter, so topped it off again just above fill line, put cover back on. Started her up and was still difficult to turn right- not as easy as to the left like it should be.
DO NOT TRY TO ANSWER UNLESS TECH HAS YEARS OF DIRECT EXPERTISE WITH PERKINS DIESEL TYPE AD3.152. I have a 1983 Massey Ferguson MF-240, Perkins diesel type AD3.152, about 1400 hours.
