Are PD130 and PD150 injectors the same?

Are PD130 and PD150 injectors the same?

I have just double checked this point myself and apologise for any confusion caused, the PD150 and PD130 injectors are exactly the same.

How to adjust the valve lash and injector height?

Torque the locknut to 41-47 N·m (30-35 lb·ft) and remove the feeler gage. Reinsert the feeler gage to ensure that the adjustment did not change when the locknut was tightened. Readjust as necessary. For diesel applications the exhaust valves are adjusted the same way as the intake valves. See Table “Valve Clearance and Injector Height Settings” .

What’s the best way to set the valve lash?

Shafrioff told us to set the valve lash with a cold engine and check the valve lash weekly with the engine at ambient air temperature. This will give you the best indication of when the lash is changing in one of the cylinders. Ignore the “Chilton Manual” method of setting valve lash.

When to set the Lash on the intake valve?

The best sequence to use when setting valve lash is to go by the firing order. This requires less turning of the crankshaft and will help ensure that valve overlap is not an issue. EO/IC rule (Exhaust Opening and Intake Closing). Set the intake valve lash when the exhaust valve is beginning to open.

What should the valve clearance and injector height be?

See Table “Valve Clearance and Injector Height Settings” . After engine serial number 4R37769 use a 0.5080 mm (0.020 in.) feeler gage. Check option label on valve cover for correct settings. It is normal for tune-up settings to vary, even when using the correct setting procedures.

What’s the best way to adjust the PD injector Lash?

The method is to use a dial indicator mounted onto the rocker, then rotate the engine until the full depth of the stroke is reached. Screw in the adjustor screw until it bottoms out. Then back it out 180 degrees.

What’s the best way to tighten an injector lever?

Use a dial type torque wrench to tighten the injector lever adjusting screws to the specified torque. If the screw causes chattering during setting, repair the screw and lever as required. Hold the torque wrench in a position that allows you to look in a direct line at the dial to insure that you are reading it accurately.

How do you adjust the injector rocker torque?

Refer to the engine model and CPL for the correct injector rocker lever adjusting screw torque value. Use a dial type torque wrench to tighten the injector lever adjusting screws to the specified torque. If the screw causes chattering during setting, repair the screw and lever as required.

How do you set the PD injector clearance?

The Bentley book gives a complicated and problematic method for setting the PD injector clearances. The method is to use a dial indicator mounted onto the rocker, then rotate the engine until the full depth of the stroke is reached. Screw in the adjustor screw until it bottoms out. Then back it out 180 degrees.