Where is the shim on a New Holland Baler?
Where is the shim on a New Holland Baler?
This causes the billhook tongue to open wider to catch the twines being held by the twine holder. (The shim is part number 773427 for the New Holland model.) 8. This photo shows the shim location.
What’s the best way to remove a retaining pin on a baler?
Take a 9/16-inch wrench on the nut at the bottom of the pinion shaft and rotate back and forth to see how much wear is present. 5. To remove the billhook pinion, raise the knotter frame up until the billhook roller is at the 7 o’clock position. Take a 3/16-inch pin punch and drive out the retaining pin.
What does twine look like on a hay baler?
When there is twine in the knotter and hay in the chamber, the billhook is pulled into this position. 4. The twine disc pinion will appear to be flat against the large cam gear.
What happens to the pinion gears on a baler?
As the pinion gears wear, the end play increases. When you get enough end play, the billhook pinion gear can jump time – or jump a tooth. After the billhook finishes its rotation, the billhook will not be in alignment with the knife arm.
What kind of baler does New Holland use?
New Holland / Hay Balers Part Diagrams 1 BR-Round Balers 2 Big Balers 3 Square Baler 4 Self-Propelled Square Baler 5 Bale Wagon 6 Self-Propelled Bale Wagon 7 BC-Series Balers
Take a 9/16-inch wrench on the nut at the bottom of the pinion shaft and rotate back and forth to see how much wear is present. 5. To remove the billhook pinion, raise the knotter frame up until the billhook roller is at the 7 o’clock position. Take a 3/16-inch pin punch and drive out the retaining pin.
What’s the shim on a New Holland knotter?
I install a shim between the pinion and the knotter frame. This keeps the bill pulled toward the billhook ramp. This causes the billhook tongue to open wider to catch the twines being held by the twine holder. (The shim is part number 773427 for the New Holland model.)
When there is twine in the knotter and hay in the chamber, the billhook is pulled into this position. 4. The twine disc pinion will appear to be flat against the large cam gear.
