What to do if your tractor has sync-shuttle?
What to do if your tractor has sync-shuttle?
If your tractor has sync-shuttle I hope the syncronizers aren’t worn out and require replacement similar to a M4900 that I once owned I have a GST transmission ,I now know all about the tire ratio for 4wd tractors. what did you have to do to your transmission and what was the cost.
Why is my John Deere tractor not moving?
Transmission issues should be diagnosed by a John Deere repair retailer. Transmissions are sealed components. Pump drive belts that have slipped or are damaged may result in the machine not moving when the engine is running.
Why does my reverser on my tractor not work?
Power reverser randomly dose not work / when it gets below 20 degrees I get an error code PTR A with no code # / the tractor starts but will not have any power steering and will not move forward or reverse. The problem goes away when I turn the tractor off and restart.
Do you clutch between shifts on a tractor?
On to clutching I do clutch between shifts hard to break that habit but I did go out and do a bunch of forward and reverse with out clutching and using foot throttle to get low rpms and not much difference. as in my first post if I plant the bucket and push the tractor back all of 1 or 2 inches it slips right in.
Where are the forward and reverse solenoids on a green tractor?
They have to be within the allowable settings. I just checked and found that the transmission on the 4720 and 3320 are either identical or almost identical. On the 3320 the forward and reverse solenoids themselves are not accessible without splitting the tractor. Hopefully you won’t have to do that.
Where are the forward and reverse coils on a tractor?
The SPN code 524069 and 524071, both with FMI 13 indicates that the forward and reverse coils need to be calibrated. The only concern here is that the 524071 FMI 5 indicates that the reverse coil resistance is higher than normal.
Where are the forward and reverse solenoids on the 3320?
On the 3320 the forward and reverse solenoids themselves are not accessible without splitting the tractor. Hopefully you won’t have to do that. The only reason that you would have to get to them is if a mouse had gotten up into that area and chewed the wiring.
Where are the forward and reverse pedals on the 4720?
The system won’t let you fudge on anything, including the voltages on the forward and reverse pedals. They have to be within the allowable settings. I just checked and found that the transmission on the 4720 and 3320 are either identical or almost identical.
