Is the 3rd brake light required in Texas?
Is the 3rd brake light required in Texas?
As of August 2017 Texas has added a new rule to the safety inspection. All vehicles require three working stop lamps (brake lights). In addition to the two standard brake lights a high center mounted brake light is now required.
What to do when your third brake light is not working?
When the lower lights do not come on and only the third-brake light works, the brake-light switch may be ruled out. Again try the emergency-flashers to check for wiring, socket and lamp problems. If the flashers work, check for blown fuses as a few vehicles use separate circuits for the lower and third brake lights.
What causes brake lights to go out but lower lights work?
If the plunger of the switch does not contact the pedal, check for an adjustment. In rare instances, the brake booster may fail, and the pedal will not rise enough to contact the switch. Pull up on the brake pedal and if the lights go out, switch mis-alignment or pedal position error is the likely cause.
Is it dangerous to drive with brake lights not working?
Driving at night with either brake lights or tail lights not working is dangerous for you and other drivers on the road. It takes a long time to notice when the brake lights not working but tail lights are or vice versa. It is so because you won’t know what is happening in the backside while driving until someone points it out.
Can a bad brake light cancel a turn signal?
With a bad turn-signal switch, the third-light should still function. On this type system, the turn signals and brakes use the same circuit. When we use the turn signal switch, it cancels the brake light signal, on the side selected.
When the lower lights do not come on and only the third-brake light works, the brake-light switch may be ruled out. Again try the emergency-flashers to check for wiring, socket and lamp problems. If the flashers work, check for blown fuses as a few vehicles use separate circuits for the lower and third brake lights.
Is the third brake light mandated by law?
A third brake light is mandated by law. Function The third brake light is normally centered and placed higher than the two typical brake lights below that flank the vehicle.
Driving at night with either brake lights or tail lights not working is dangerous for you and other drivers on the road. It takes a long time to notice when the brake lights not working but tail lights are or vice versa. It is so because you won’t know what is happening in the backside while driving until someone points it out.
With a bad turn-signal switch, the third-light should still function. On this type system, the turn signals and brakes use the same circuit. When we use the turn signal switch, it cancels the brake light signal, on the side selected.
