Where is the feeler gauge on a 3406E?
Where is the feeler gauge on a 3406E?
Place the appropriate feeler gauge (5) between the inlet rocker arm and the inlet valve bridge. Turn the inlet adjustment screw (4) while the valve adjustment locknut (3) is being held from turning. Adjust the valve lash until the correct specification is achieved. Refer to Table 6.
What should the torque be on a 3406E?
Turn the slave piston adjusting screw in a clockwise direction until the slave piston tightens against the feeler gauge. A slight drag should be felt on the feeler gauge. Tighten the adjustment locknut (1) to a torque of 35 N·m (25 lb ft). Recheck the adjustment after you tighten the locknut.
How to adjust the exhaust valve on a 3406E?
Make an adjustment to the valve lash on the exhaust valves for cylinders 1, 3, and 5. Loosen the valve adjustment locknut (1) . Place the appropriate feeler gauge (5) between the exhaust rocker arm and the exhaust valve bridge. Turn the exhaust adjustment screw (2) while the valve adjustment locknut (1) is being held from turning.
What are the slave piston Lash settings on a 3406E?
Some of the early 3406E Engines, 5EK1-01820 were built with either the 340 or the 340A compression brakes. Note: The slave piston lash settings are specific to the model number of the compression brake and to the serial number prefix of the engine.
Place the appropriate feeler gauge (5) between the inlet rocker arm and the inlet valve bridge. Turn the inlet adjustment screw (4) while the valve adjustment locknut (3) is being held from turning. Adjust the valve lash until the correct specification is achieved. Refer to Table 6.
Turn the slave piston adjusting screw in a clockwise direction until the slave piston tightens against the feeler gauge. A slight drag should be felt on the feeler gauge. Tighten the adjustment locknut (1) to a torque of 35 N·m (25 lb ft). Recheck the adjustment after you tighten the locknut.
Where can I find part number for Jake brake?
In this section, you’ll find a part number cross-reference tool, parts and service literature, service locations, and answers to frequently asked questions. The tools and wizards will help you fill in all necessary information to locate the right tune-up kit and application for your truck’s Jake Brake®.
What kind of compression brake do I need for a 3406E?
Check the identification plate that is on the compression brake’s casting in order to determine the model that is installed on your engine. Some of the early 3406E Engines, 5EK1-01820 were built with either the 340 or the 340A compression brakes.
