Why do I have code 285 and code 241 active?
Why do I have code 285 and code 241 active?
Make sure the throttle pedal is calibrated to the ecm this can be the cause of the 285. to calibrate key on press throttle 3 times slow and key off. This fault 241 is set active when the ECM loses a vehicle speed signal when other engine conditions indicate the vehicle is moving.
Why do I have code 285 on my car?
Wheel-Based Vehicle Speed – Data Erratic, Intermittent or Incorrect. The ECM lost the vehicle speed signal. Engine speed limited to Maximum Engine Speed without VSS parameter value. Cruise control, Gear-Down Protection, and Road Speed Governor will notwork.
What is the ISC Code for a Cummins solenoid?
322 Injector Solenoid Driver Cylinder 1 Circuit – Current Below Normal, or Open Circuit 323 Injector Solenoid Driver Cylinder 5 Circuit – Current Below Normal, or Open Circuit
Make sure the throttle pedal is calibrated to the ecm this can be the cause of the 285. to calibrate key on press throttle 3 times slow and key off. This fault 241 is set active when the ECM loses a vehicle speed signal when other engine conditions indicate the vehicle is moving.
What does active code 285 do for Insite?
1. Allows activation of service brake switch to cancel idle shutdown 1. Reduces occurrences of multiple inactive counts of fault code 2636 2. Reduces occurrences of fault code 242 3. Enables fault code snapshot within Insite 4. Allows throttle override to work when using Remote PTO 5.
What does active code 285 in FMI 9 do?
1. Reduces occurrences of multiple inactive counts of fault code 2636 2. Reduces occurrences of fault code 242 3. Enables fault code snapshot within Insite 4. Allows throttle override to work when using Remote PTO 5. Reduces occurrences of the ECM going into a ROM boot state on key off
Why do I have a code 285 fault?
This fault 285 can occur for the following reasons: When the ECM is set up properly (components enabled and OEM VECU source addressed correctly) to receive information from an OEM VECU, but the OEM VECU is actually transmitting a message that says that component is notavailable for multiplexing.
