Why does my tractor not turn off with the key?

If it is, move on down the tractor harness making sure that any plug that wire goes into is secure. Eventually that wire will lead up to the ignition switch. It’s possible for the ignition switch to be the problem but I don’t think it’s likely because the seat switch isn’t doing what it should be doing.

Is there ground cable for Hinomoto tractor battery?

First off, welcome to Tractor Forum Jim! :friends: :cheers: You are our very 1st Hinomoto owner to post here! Great to have you aboard! Have you cleaned and inspected ALL of the battery connections to include the ground cable from the battery to the frame?

How did I Fix My NEG on my Tractor?

Hmm, after scratching my head I disconnected the neg. from where it was connected and ran it directly to the frame (It was bolted to a steel mount that was connected on one end to the frame and the other end to the radiator). Yup, the problem was solved by moving the ground to a different place on the frame.

When to replace the solenoid on a riding mower?

You’ll hear the solenoid click when the ignition switch activates the solenoid. Replace the solenoid if it doesn’t click when it gets power from the ignition switch. You’ll also need to replace the solenoid if it clicks but doesn’t send current to the starter motor to spin the engine.

Why does my riding mower click when I turn the key?

If you hear a click when you turn the key, a dead battery, bad starter solenoid, failed starter motor or a seized engine could be the cause. Our riding mower engine clicks but doesn’t turn over video will help you figure out what to fix.

What to do if your tractor clicks but not turning over?

A small amount of petroleum jelly can prevent future build-up as well. If there is something wrong with the battery, the first thing you need to do is check it for leaks. If it is leaking, replace the battery. Be careful when you are checking on this since battery acid can be very dangerous.

Where does the vacuum go when the key is turned off?

The vacuum then goes back to your ignition key assembly under the dash and back out to the shut-off valve on the back of your injection pump. When you turn your key OFF vacuum is routed through the back of the switch and on to the shutoff valve.

What happens when you turn off the car key?

When you turn off the key, you expect the car to stop! It can be very frustrating when it doesn’t. If the engine continues to run just as before you turned it off – as if you hadn’t turned it off at all – your ignition and fuel system are not shutting down.

Why is the ignition dead on my Cat 305?

A couple times when the key in off position I could hear a buzzing coming from under the seat by the hour meter, turn key on and the buzz would quit, or when it was buzzing with key off it would quit on its own after 5 seconds or so. Now key in the on position is totally dead and in the off position there is no noises either.

What was the problem with my excavator this morning?

Started the excavator this morning to move it 50 feet out of the way, started fine, shut it off, about a hour later came back and tried to move it and when turning the key on it would beep, fuel needle moves, dash lights came on which is all normal but when I hit they key everything goes out and starter doesn’t engage or make any noise.

What happens if the ignition switch is not working?

The ignition switch sends power to the the starter motor, engine controls, and ignition controls. These systems may not receive the power they need to start up if the ignition switch isn’t working properly. An engine not starting could be one of them. 3. Car starts and then suddenly stalls

Why is the seat switch not working on my Tractor?

The seat switch does not work either. The only wiring I see going to engine is the fuel shut off wires. I pull those and the engine continues to run Share it! Click to remove this tagging. You’ll need to take the engine shroud off the engine. You will see the ignition module on the front top of the engine.

What causes a fuel pump ignition switch to fail?

If the switch fails during heavy accessory loads, the internal contacts may have become heavily oxidized. In any case, most switches give ample warning of an impending failure under various conditions of temperature and load. Fault in the fuel pump circuit

What happens when an ignition switch goes bad?

This causes the engine to stall. Engine won’t start: The ignition switch supplies power to starter motor, ignition system and engine controls. A faulty switch can prevent these systems from getting power, resulting in an engine that won’t start.

Why is my starter not working on my Tractor?

Might also be a seat operator presence safety switch as well. Check all of these and try by passing them. Another possibility could be the ignition switch itself. Lastly, look at the starter, could be a bad starter or solenoid on the starter but I think this is unlikely.

Why does my tractor not turn off with the key?