Can a FICM be used as an IDM?
Can a FICM be used as an IDM?
The FICM is sometimes referred to as an IDM for this truck as well. Our staff is extremely knowledgeable about the FICM and can help you troubleshoot and diagnose problems you are having to determine if they are FICM related or not.
Why does my engine quit when the IDM shuts down?
The actual code is just saying the ecm cannot get the idm to communicate fault codes. This alone does not cause the engine to quit. If the IDM is loosing power and shuts down there are other codes that get logged in the ECM for loss of signal and other communication break downs with the IDM.
Where does the IDM get its power from?
The IDM is powered through at relay. The relay should also be near the IDM itself at the firewall there. The relay is turned on by the ECM. The relay gets it battery power directly from the batteries by a separate ECM/IDM power harness.
Where is the ECM located on an International T444E crank?
The injector drive module is located above the engine on the firewall, the ecm is located kinda above where the clutch pedal is on the inside of the firewall and has a big connector that connects to it through the firewall at the left side near the fender. The actual code is just saying the ecm cannot get the idm to communicate fault codes.
Where can I find a 2007 IDM relay?
I HAVE A 2007 INTERNATIONAL 4300, LOOKING RELAY LOCATION, I HAVE A 2007 INTERNATIONAL… I HAVE A 2007 INTERNATIONAL 4300, LOOKING FOR IDM RELAY LOCATION, Show More Show Less
Is the IDM on my DTC 525 bad?
It doesnt show symptoms of a fault but it has the engine light on. It turns on and runs fine. I have checked the voltage to the IDM relay and its getting 12.4. I believe next i have to check the power getting to the IDM itself before concluding the IDM is bad but I need help on this one if anyone can give me any ideas.
The FICM is sometimes referred to as an IDM for this truck as well. Our staff is extremely knowledgeable about the FICM and can help you troubleshoot and diagnose problems you are having to determine if they are FICM related or not.
How often does an IDM relay go bad?
When I get that 525 code, I will check the fuse in the battery box first and replace that fuse jumper if needed, followed by the relay and the IDM last. The IDMs do go bad, but not very often. (0% of the time it is the fuse or the fuse holder at the battery box with 8% being the relay and 2% being the IDM.
