Where can I find the John Deere 4010 serial number?

Open operator station. Transmission details John Deere 4010 photos… Full dimensions and tires Serial number plate on the rear of the tractor, above the PTO shaft. how to read serial numbers… ©2000-2021 – TractorData.com®. Notice: Every attempt is made to ensure the data listed is accurate.

How does the 24 volt system work on a John Deere tractor?

Any ground within the 24 volt system will cause current to drain from the batteries. Again: the Entire cranking and charging circuit is carried by wires…No part of it is grounded to the tractor frame. Voltage from Battery A controls left hand or flywheel side of tractor.

What kind of electrical system does a John Deere tractor use?

3. 12 volt system controlling the opposite side of the tractor Take one 12 volt system off the tractor and what is left is a typical 12 volt system. With this system the difference is the generator brushes are both connected to the regulator instead of grounding one. The field circuit wire is connected inside

Where does the current go in a John Deere?

The current then goes from A 1 to the voltage regulator ARM terminal, through the regulator, out the Blue wire to BAT A on Ignition Switch, to load if needed (lights, etc) If no load, then current will flow on Blue wire from BAT on Regulator to solenoid and on to Battery A. If current is needed for both battery re-charge and load, then it will be

What was the John Deere 4010 tractor known for?

John Deere’s innovative 4010 tractor was easily one of the greatest successes any tractor company had since the industry was created. The 4010 included a plethora of innovative features that the rest of the industry either hadn’t even dreamed of yet or were only just experimenting with.

What was the model year of the John Deere 4020?

The 1965 model year tractors included one more change. The first 4020 standards had the same fenders that the 4010 tractors wore. For 1965, 4020 standard tractors began using a different type of fender that included headlights in the front.

What kind of hydraulic problem does a John Deere 4020 have?

Mike I have a John Deere 4020 Diesel with a syncro-range transmission. With engine idling, when you push in the clutch, the power steering cuts out and you lose the power brakes. Also, I don’t know if it’s related, but the 3-point will settle quickly with the engine off, and is initially slow to raise.

What kind of steering problem does a 4020 Diesel have?

I have a 4020 diesel that has developed an annoying habit of veering off to the right when driving. If you are quick and turn left it will straighten up but obviously it is dangerous on the road. When i start it and it is stationary it turns to the right on its own.

What to do about steering problem in tractor 69 3020?

I did the leak test at the hyd. cooling tower by unhooking the hose from the front steering motor and putting it in a can and then started tractor, 69 3020, turning wheels first to the right and then to the left and I got just a few drops of oil with each direction turn.

Are there any errors in John Deere tractors?

Notice: Every attempt is made to ensure the data listed is accurate. However, differences between sources, incomplete listings, errors, and data entry mistakes do occur. Consult official literature from the manufacturer before attempting any service or repair.

Can a John Deere 9600 combine lose power?

Hi, we have a John Deere 9600 Combine with around 3500 hrs and the Hydrostatic drive has lost power. The control lever was required to be moved further to maintain speed but over a period of about 1 hour it has got to the point of no drive.

Is there a John Deere tractor that will kill?

I have a John Deere… I have a John Deere 4010 diesel tractor that would act like it was under a load and would kill. So, I decided to change the fuel filters. After doing so, I bled the filters, and tried to start the tractor. Now the tractor will start and then kill after a few seconds.

What should I do about my John Deere tractor?

I have a John Deere 4010 diesel tractor that would act like it was under a load and would kill. So, I decided to change the fuel filters. After doing so, I bled the filters, and tried to start the tractor. Now the tractor will start and then kill after a few seconds. What seems to be the problem, what should I check next ? There is plenty of fuel .

How many amps does a John Deere battery take?

200-amp engine start for 12-volt batteries; 30-amp rapid charge for 6- and 12-volt batteries; 10-amp fast charge for 12-volt. Combines a starter and charger with the convenience of circuit-controlled, fully automatic operation. 50-amp engine start; 10-amp rapid charge; 2-amp slow charge for 6- and 12-volt batteries.

How long does it take to charge John Deere lawn mower battery?

From our StrongBox™ Original Equipment to our StrongBox™ Standard-Duty line, we have the battery for your lawn mower, ATV/UTV, SUV, agricultural and construction equipment, and more. Heavy-duty design charges vehicle, boat, and heavy equipment batteries in one to three hours. 250-amp engine start for 12-volt batteries; 125-amp start for 6-volt.

Where can I find the John Deere 4010 serial number?