Why does my dt466e take so long to start?
Why does my dt466e take so long to start?
The high psi oil system, in a dt466e you have high psi oil that fires the injectors, and sometimes the pump can actually bleed down overnight causing it to take forever to start, the only way to check that will be let it sit overnight and there is a temp sensor in the front cover/ drivers side . it is right in front of the oil/fuel pump.
What should fuel psi be on dt466e International diesel?
Usually when we get no start cold but fires and runs after using ether it might be injectors, but you need to do the fuel checks I posted and let me know. If you don’t have a fuel psi gauge, autozone loans them out. I like to have around 60psi I have seen them run ok above 45psi.
Why does my dt466e diesel engine not start?
DT466E international diesel wont start… Will it stay running, after you ether it? Or does it just die out again? Do you have access to a scanner, any engine light on? Does the tach read while you are cranking? Can you use the hand primer on the filter base to try and prime system, if it does not get hard to pump you are most likely sucking air.
The high psi oil system, in a dt466e you have high psi oil that fires the injectors, and sometimes the pump can actually bleed down overnight causing it to take forever to start, the only way to check that will be let it sit overnight and there is a temp sensor in the front cover/ drivers side . it is right in front of the oil/fuel pump.
Usually when we get no start cold but fires and runs after using ether it might be injectors, but you need to do the fuel checks I posted and let me know. If you don’t have a fuel psi gauge, autozone loans them out. I like to have around 60psi I have seen them run ok above 45psi.
DT466E international diesel wont start… Will it stay running, after you ether it? Or does it just die out again? Do you have access to a scanner, any engine light on? Does the tach read while you are cranking? Can you use the hand primer on the filter base to try and prime system, if it does not get hard to pump you are most likely sucking air.
Is the IH 4300 DT466 getting hard to start?
I have an 05 IH 4300 DT466 with 131K miles on it. I have had a small problem with it before, usually first thing in the AM. But now it doesn’t want to start no matter what time of the day it is. If its been sitting for any length of time it cranks and will finally start after about 45 seconds.
