What is the DTC for O2 sensor malfunction?
What is the DTC for O2 sensor malfunction?
P0136 is a diagnostic trouble code (DTC) for “O2 Sensor Circuit Malfunction (Bank 1, Sensor 2)”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation. Our certified mobile mechanics can come to your home or office to perform the Check Engine Light diagnostic.
What do I need to know about the p0135 Dodge O2 sensor?
Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. P0135 DODGE Tech Notes The code means that there is a problem with the heater element circuit of the heated oxygen sensor. The control module monitors how long it take the sensor to warm up and start sending an adequate signal.
Why is my O2 sensor not working on my Toyota 4Runner?
One of the vehicles it didn’t work with was a 1997 Toyota 4Runner with the V6 engine. In this case there was voltage on both wires to the O 2 sensor heater circuit. Most computer systems will also monitor the current flow to the sensor. The light’s current draw was not within the operating range of this system’s heater circuit.
Where is the O 2 sensor on a 2000 Jeep Grand Cherokee?
When you locate the area of the short, the light may again flicker or go off. In the case I was called in on, the vehicle was a 2000 Jeep Grand Cherokee with the 4.0L engine. The vehicle’s O 2 sensor harness was pinched underneath the valve cover at the back of the cylinder head.
When you locate the area of the short, the light may again flicker or go off. In the case I was called in on, the vehicle was a 2000 Jeep Grand Cherokee with the 4.0L engine. The vehicle’s O 2 sensor harness was pinched underneath the valve cover at the back of the cylinder head.
One of the vehicles it didn’t work with was a 1997 Toyota 4Runner with the V6 engine. In this case there was voltage on both wires to the O 2 sensor heater circuit. Most computer systems will also monitor the current flow to the sensor. The light’s current draw was not within the operating range of this system’s heater circuit.
How to diagnose O2 sensor heater circuit failure?
The modified test harness with the light will give you easy access to the circuit. Remember, the engine needs to be running at this point. If the voltage is close to zero on the positive heater wire, then locate the open circuit in the power wire back to the fuse. Again, it may have a relay in the circuit as well.
