What do front axle U-joints do?

Some four-wheel drive vehicles also use U-joints to connect front axle shafts to the front wheels, and these U-joints allow torque to be provided to the front wheels when they are turning. Drive shafts and U-joints provide an efficient and durable means of transferring engine torque to the drive axles.

How to change front axle U-joints in Dodge?

If there is play in the U-joint, replacement is required. Loosen the lug nuts on the front wheels of your Dodge with a lug wrench. Raise the truck using a jack and support the front end on a set of jack stands. Remove the tires and wheels, setting them aside for now.

Can you change the U joint with the hub off?

With the Hub off you can now pull out the axle shaft in order to change the U Joint. The shaft just slides out. Be careful when getting the U joint out to not damage the splines on the shafts. There are clips on each ear of the U Joint that hold the Joint in place.

How do you remove a U joint from a shaft?

Be careful when getting the U joint out to not damage the splines on the shafts. There are clips on each ear of the U Joint that hold the Joint in place. Carefully push them out. Now you can remove the U Joint. The easiest way to do that is with a press.

How to replace a front axle on a Dodge Ram?

This video covers how to replace a front axle universal joint and a hub or wheel bearing in a 1999 dodge ram 1500 4 wheel drive. Very similar to a 2500. It may be less damaging to loosen the hub bolts and tap on them with a hammer vs the method shown in this vid. Loading…

What’s the best way to replace a universal joint?

Dislodge the universal joint from the both the yoke and the driveshaft. Remove all dirt and debris from the entire drive shaft assembly, assuring that it is completely clean. Apply a small amount of grease to the replacement caps.

How do you reattach a transmission universal joint?

Reattach the universal joint mounting clamps or clips. Insert the grease fitting and apply grease. Inspect the universal joint to confirm proper installation. Remove the jack stands and lower the vehicle. Confirm that the transmission drain plug has been reinserted and refill the transmission with fluid.

How do you replace a you joint on a hard drive?

Place a support under the driveshaft and tap the yoke with a hammer to break it free. The yoke is the metal piece connected to the driveshaft. The U-joint attaches the yoke to the driveshaft, so find that joint if you can’t find the yoke at first.

What do front axle U-joints do?