How big is the Torx bolt on a Mercedes injector?
How big is the Torx bolt on a Mercedes injector?
Remove the long single 6mm torx bolt that secures the injector clamp and place it safely to one side with the clamp itself.
What kind of injector do I need for a 2.2 litre diesel?
This washer is the standard CDI injector seal used on all modern Honda 2.2 litre diesel engines (More info on the Honda seal – here ). I personally have had great success using the Honda part as they seem to be made from a superior material and appear more compressible thus making a better seal against any slight face imperfections.
Where is the injection pump gear cover located?
On early 6.9 engines, the cover is the oil fill tube. These engines typically do not have a tachometer sensor installed. On all 7.3 and later 6.9 engines, the injection pump gear cover is a metal plate located on the front of the injection pump gear housing, and in all cases, is held on by two bolts. Remove the bolts, and remove the plate.
How do you remove the injector from a Yanmar Diesel?
Remove the injector line from the top of the injector with a wrench. Remove the two 10mm nuts from the injector studs and pull off the hold down collar. Thread the injector puller tool onto the top of the injector. Slip on the injector puller tube, aligning the notches on the tube with the injector bleed tubes.
How do you remove timing gear from Idi fuel injection pump?
Proceed by removing the 5/16” bolts holding the timing gear to the injection pump. These bolts require a 16 point socket or open end wrench. The bolts are accessed through the hole exposed by removal of the cover in the previous step. Be careful not to misplace these bolts.
How do you remove an injection pump gear access cover?
The return line at the top of the pump is rubber, and can simply be removed by unclamping the line at the pump, and pulling the hose off the barb. Next, remove the injection pump gear access cover. On early 6.9 engines, the cover is the oil fill tube. These engines typically do not have a tachometer sensor installed.
What kind of wrench do I need for fuel injection?
Remove the bolts, and remove the plate. Note that silicon gasket material is used to seal this part, and it will be necessary to clean off all the old gasket material before reassembling. Proceed by removing the 5/16” bolts holding the timing gear to the injection pump. These bolts require a 16 point socket or open end wrench.
How is throttle cable removed from injection pump?
The throttle cable is removed from the injection pump, by simply pulling the cable off the ball (pull or pry towards the passenger side fender). If you are going to reinstall the same injection pump for any reason, be sure to mark the relationship between the pump and pump housing, to preserve the timing setting.
