How do you remove the fuel tank from a Dodge truck?
How do you remove the fuel tank from a Dodge truck?
Move to the fuel door located on the truck panel. Ignore this step for older, cab-mounted fuel tanks. Open the fuel door and remove the fuel cap. If the cap has a security line attached to it, remove the line from the fuel door frame with a Phillips screwdriver. You will see three screws that hold the tank filler neck to the truck bed frame.
How to remove the bed from a Dodge truck?
How to Remove a Dodge Truck Bed. 1 Step 1. Raise the hood. Disconnect the negative battery cable at its post with an end wrench. Use the floor jack to lift the rear end of the truck up 2 Step 2. 3 Step 3. 4 Step 4.
How do you remove a taillight from a Dodge truck?
Disconnect the wire jack connection (both taillights) by pushing the pressure clip and unsnapping it. If the wires run down without a connection jack, take the screws out of the taillight lens with a Phillips screwdriver, pull out the lens and disconnect the wire jack at the back of the lens housing.
Why is my Dodge Powertrain Control Module not working?
There are several reasons why you might want to reflash your Dodge Powertrain Control Module. – The vehicle is showing false trouble codes. – The original factory PCM programming might be overly sensitive or not take into account wear or other factors that may affect the operation of individual sensors or the OBD II monitors.
Move to the fuel door located on the truck panel. Ignore this step for older, cab-mounted fuel tanks. Open the fuel door and remove the fuel cap. If the cap has a security line attached to it, remove the line from the fuel door frame with a Phillips screwdriver. You will see three screws that hold the tank filler neck to the truck bed frame.
Disconnect the wire jack connection (both taillights) by pushing the pressure clip and unsnapping it. If the wires run down without a connection jack, take the screws out of the taillight lens with a Phillips screwdriver, pull out the lens and disconnect the wire jack at the back of the lens housing.
How do you remove brake rotors on a Dodge Ram?
While removing the brake rotors was basically the same for the 1/2-ton and 3/4 ton Rams, the 1-ton version added a slightly different procedure. Lift the Dodge Ram on a vehicle or truck lift to a suitable height to work on. Remove the lug nuts using an impact gun and a 7/8-inch impact socket or a 22 mm impact socket.
