What does the error code p1495 stand for?

What does the error code p1495 stand for?

Error Code P1495 refers to a problem in the vehicle’s leak detection pump, which is part of the emission system. This code is detected when the PCM (powertrain control module, also known as ECM or engine control module in other vehicle makes) determines that the solenoid did not change status when activated.

How much does it cost to repair a p1495 Dodge?

The cost to diagnose the P1495 DODGE code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

What is the error code for VAP leak detection pump?

Error Code P1495 is defined as VAP Leak Detection Pump Solenoid Circuit Condition. This code pertains to a fault in the Leak Detection Pump. This error code is a manufacturer-specific trouble code, meaning it does not apply to all vehicles makes. Rather, it applies only to specific vehicle makes, such as Chrysler, Dodge, and Jeep.

What does code p-1494 mean?

P1494 means Leak Detection Pump Switch or Mechanical Fault – This code appears when there’s an issue with the EVAP System (fuel tank fumes) This can be caused by a improperly secured gas cap, faulty gas cap, crack in the vacuum line, etc.

What does this code mean p1494?

The Dodge P1494 engine light code means Leak Detection Pump Switch or Mechanical Fault. A proper diagnosis must be done, you can’t simply replace the LDP and expect that to fix the problem.

What do codes p1294 and p1494 mean?

It says engine codes 1294. P1294 (M) Target Idle Not Reached Target RPM not achieved during drive idle condition. Problem vacuum leak or IAC (AIS) lost steps. And code 1494. P1494 (M) Leak Detection Pump Sw or Mechanical Fault Incorrect input state detected for the leak detection pump (LDP) pressure switch.

What is OBD code p1494?

OBD II fault code P1494 is a manufacturer specific code that is defined by car makers Chrysler, Dodge, Jeep, and Plymouth as “EVAP Leak Detection Pump Pressure Switch Condition”, or sometimes as “Leak Detection Pump SW or Mechanical Fault”, or less often as “Mechanical Incorrect input state detected for the Leak Detection Fault Pump [LDP] Pressure Switch”, depending on the application and manufacturer.