How to tell if a Mercedes Sprinter has a fault?
How to tell if a Mercedes Sprinter has a fault?
If no control voltage is present look for a break in the wiring from the valve to the ECU. Trace back the wires to the ECU connector and prove continuity exists from the ECU connector to the valve. Pin outs and wire colours are given in the included diagrams.
What to do if your Mercedes Sprinter has a split pipe?
Check vac supply to this device observing and rectifying any split or leaking pipework. Once good vacuum supply has been determined, with the ignition off (no power to the valve and no vacuum present) the route of vacuum should be blocked by the valve to the turbo actuator.
Why is my transmission leaking through wire harness?
The assembly snaps into the case and the 3 prongs “latch” it in place. The possibilities are Two (2) either the O ring on the Bulkhead is bad or the plastic bulkhead itself is leaking past a connector or maybe cracked.
What causes Turbo limp home in Mercedes Sprinter?
That is why the dreaded turbo limp home fault often occurs without any indication on the dashboard. Normally Sprinter engine revs are ECU limited whilst stationary to around 3500 rpm. Depressing the clutch and then further releasing it should now allow revs to increase above this range to the rev limit.
What should I replace the drain plug on my Mercedes Sprinter?
New replacement drain plug with seal for the torque converter for the Mercedes Benz 7-speed 722.9 transmission. The seal is not New replacement drain plug with seal for the torque converter for the Mercedes Benz 7-speed 722.9 transmission. The seal is not…
What to do if your sprinter has a leak?
If a visual inspection doesn’t reveal a clear leak but you still suspect one may be the problem, investing in an Intercooler Pressure Tester may be a good idea. These devices allow you to pressurize the intake and intercooler system and find any leaks you may have.
What causes a Mercedes 5 speed transmission plug to leak?
The transmission 13 pin connector plug causes the majority of transmission slip or delayed engagement problems on the Mercedes Benz 5 speed transmission. It leaks transmission fluid to the 13 pin connector and causes the car to loose communication with the valve body.This is a common problem on the Mercedes Benz cars from 1998- up to 2008.
What is the transmission code for a Dodge Sprinter?
The seal is not… Complete service kit with fluid for the 5-speed automatic transmission 2002-2012 T1N & NCV3 Sprinters. While both models use the same generation transmission, the Mercedes models lists the transmission code as 722.6 while the Dodge-branded Sprinter models list this transmission code as NAG1.
