How do you adjust the position of the ring gear to achieve the backlash?
How do you adjust the position of the ring gear to achieve the backlash?
If using shims: Adding shims on the ring-gear’s smooth side of the carrier moves the ring-gear closer to the pinion, causing the teeth to mesh tighter, decreasing the amount the backlash. Adding shims on the other side moves the ring-gear teeth away from the pinion, increasing backlash.
How to mount a ring and pinion set?
Nicks or burrs can be removed by using block-backed grit paper or a small file. Following material removal, rewash in solvent and air dry. Mount ring gear. Loctite ring gear bolts and torque to factory specifications. STEP 9:All Ford Racing ring gear and pinions have been “Lapped” in sets and should never be mixed with another ring gear or pinion.
How big is a 9.75 ring and pinion set?
SPECIFICATIONS Description 9.75” and 10.25” Ring Gear 7.5” and 8.8” Ring Gear Backlash between ring gear 0
How to do ring and pinion change on Silverado Sierra?
Step 22: Use large pipe wrench and clamp onto yolk where drive shaft came off of and then break the pinion nut loose. The pinion nut was a 1 ¼ on my truck. Step 23: Take nut off and pull off yolk. Both are in the picture. Step 24: Put nut back on and use the sledge hammer to knock the pinion out.
How much torque does a pinion set have?
TORQUE SPECIFICATIONS Description 9.75” and 10.25” Ring Gear 7.5” and 8.8” Ring Gear Driveshaft flange bolts 76 lb-ft with loctite 70-95 lb-ft with loctite Filler Plug 22 lb-ft 15-30 lb-ft Minimum torque required to tighten pinion flange nut – 140 lb-ft
How to set up ring and pinion gear?
Ring and Pinion Gear Set Up To install your ring and pinion gears and/or differential correctly, it is critical to torque your bolts and set your preload and backlash correctly. The following table contains the proper specifications for all popular axles.
How is the pinion depth of a ring adjusted?
1. Pinion Depth ± The distance from the face of the pinion gear to the centerline of the ring gear. This is adjusted by adding or subtracting shims to the inner pinion bearing. 2. Pinion Bearing Preload -The preloa d applied to the pinion bearings when the pinion nut is tightened. This is adjusted by shims and/or a crush sleeve. 3.
How do you mount a pinion ring on a Ford?
Install the front bearing and carefully tap the pinion seal in place with a properly sized seal driver or an old race. West Coast Differentials notes that Ford 8- and 9-in., and GM 10.5- and 12.25-in. ring gears use a pilot bearing that must be tapped in, with a retainer for the Fords. Mount the ring gear to 30 October 2015
How to clean a ring and pinion set?
STEP 1: Remove the old gear set and thoroughly clean both the ring gear carrier and rear end housing with solvent. After cleaning, air dry all parts. STEP 2:Always verify you have the correct gear ratio that you have purchased.
