What should I do if my pannel gauges dont work?
What should I do if my pannel gauges dont work?
No Istru. pannel gauges… All my gauges and instuments dont work.No Speedo and or tach ,Last week replaced ADS Fuse under hood and solve prob . Mot so lucky this week. My odometer reads NO BUS and Diaognostic computer says it is code 1687. Any idea what 1687 is and what to do to get pannel back?
What is the instrument cluster on a Dodge Ram?
The Instrument Cluster is the hub that allows the ABS, Engine Computers et all to talk to each other. I would have a really good shop verify this with a good scanner that is CAN BUS capable. I have a 2001 Dodge Ram 1500 4×4 with a 5.9 liter (360) motor, has 121,000 miles on it.
Can you replace the instrument cluster on a Dodge Durango?
While quality is a trademark of Dodge, any dash cluster is susceptible to problems at any time. Whether you’ve got a stuck needle on your Durango, a flickering light that’s driving you nuts, or an entirely dead LCD display in your Dodge Caliber, Instrument Cluster Store can help you replace or repair your instrument cluster with ease.
Why is my speed ODM gauge not working?
The cause of problem: bad connection under fuse box going to hazard circuit. The connection plug pins had some corrosion on them. This allowed voltage to travel through that circuit but not enough current.
No Istru. pannel gauges… All my gauges and instuments dont work.No Speedo and or tach ,Last week replaced ADS Fuse under hood and solve prob . Mot so lucky this week. My odometer reads NO BUS and Diaognostic computer says it is code 1687. Any idea what 1687 is and what to do to get pannel back?
The Instrument Cluster is the hub that allows the ABS, Engine Computers et all to talk to each other. I would have a really good shop verify this with a good scanner that is CAN BUS capable. I have a 2001 Dodge Ram 1500 4×4 with a 5.9 liter (360) motor, has 121,000 miles on it.
The cause of problem: bad connection under fuse box going to hazard circuit. The connection plug pins had some corrosion on them. This allowed voltage to travel through that circuit but not enough current.
How do you reset fault codes on a Dodge Ram?
When all fault codes have been displayed, the cluster will display “end” or “E” for end in the odometer display. You can also try a reset by disconnected the negative battery cable and leave it over for about 1/2 hour. This should reset most of the codes on your Dodge (just remember that it will also reset the codes on your radio:-)”
