How do you reset the service light on a Dodge Ram 1500?

How do you reset the service light on a Dodge Ram 1500?

How to Reset Oil Life/Service Reminder on the Dodge RAM 1500, 2500, and 3500

1. Place the ignition in the “ON/RUN” position.
2. Push the accelerator pedal slowly 3 times within a 10 second interval.
3. Turn the ignition off.
4. When you start the vehicle again, the Oil Life will be reset.

What is the maintenance light reset on a Dodge Ram?

2006-2010 Dodge Ram 1500 / 2500 Oil Change Maintenance Light Reset – The outer look of the Dodge Ram 2500 looks so dark. No one did, because the car we tried a special edition 2500 Dodge Ram 2014 Laramie Blackout Edition.

How to reset the oil change light on a Dodge 1500?

Turn the ignition off and start the engine to verify the indicator has been reset. Repeat this procedure, if the message still illuminates when you start the engine. These instructions are based on the Dodge owner’s manual. This procedure should be work on the third generation of Dodge Ram 1500 2500 (2006 2007 2008 2009 2010 model years).

When does the service light go out on a Dodge truck?

When it’s time to get maintenance done on your Dodge truck, a service light indicating that maintenance is required will illuminate. This maintenance light, however, will not go out until or unless you reset the system.

How can I Reset my OBD-II check engine light?

If you don’t have or don’t want to buy an OBD-II scanner, you can reset your check engine light by disconnecting the negative (black) battery terminal using a 1/2″ wrench. After you disconnect the terminal, turn the ignition to the “on” position for ten seconds, turn it off, and then reconnect the negative battery terminal.

How to reset check engine light on Dodge Ram 1500?

(Good news: it is very easy!) Step 1: Disconnect the battery: You don’t need to remove the battery entirely, actually. You just need to remove the negative end of it. Step 2: WAIT: Waiting is crucial. You need to be patient for a minimum of 20 minutes at this point.

How to clear the maintenance required light on Dodge truck?

Make sure that you perform the required maintenance for the truck prior to shutting off the light. When you’re ready to do this, you’ll need a special tool, called a diagnostic reset tool, which is available from Dodge (or a Dodge dealership).

Why do I need to Reset my Check Engine light?

To make it go away, you have to reset the powertrain control module (PCM), which among its many jobs is also in charge of the check engine light. There are other reasons why you would need to reset the PCM, such as after the installation of aftermarket components that require a PCM reset so the truck can fully adjust to new components.

Where is the reset button on a Dodge Ram?

The reset procedure in your Dodge Ram is as easy as they come. First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch on the front of the hood to open it. Find the power distribution center (PDC); it will be a black box near the battery.