What kind of power steering fluid does Dodge use?

THIS IS A COMPLETE REVISION AND NO ASTERISKS HAVE BEEN USED TO HIGHLIGHT REVISIONS. The factory fill power steering fluid for most 2004 model year Chrysler Group vehicles is ATF+4 (MS9602) and it provides superior performance at both low and high temperatures.

What kind of lubricant does a Dodge Dakota use?

Royal Purple® Max ATF® is a synthetic, high performance, automatic transmission fluid. Its high film strength helps to dramatically reduce heat and wear…. The Dodge Dakota is a mid-size pickup truck from Dodge Truck / Ram division of Chrysler manufactured from 1987 to 2011. In the U.S. it was manufactured over three generations.

How much water is in a Dodge Dakota?

Dakota Fluid Capacities (1) Includes 0.9L (1.0 quarts) for coolant reservoir. (2) If equipped with Trac-lok add 0.25 pints (118mL) of Limited Slip Additive. (3) Dry fill capacity depending on type and size of internal cooler, length and inside diameter of cooler lines, or use of an auxiliary cooler, these figures may vary.

What kind of brake fluid is used in a Dodge Dakota?

DOT 4 brake fluid is a high-quality brake fluid recommended for use in the hydraulic brake and clutch systems of all cars, commercial vehicles and motorcycles for which a glycol-based DOT 3 or DOT 4 fluid… GM Original Equipment™ Auto Trak II Transfer Case Fluid, 1.05 Quart by ACDelco®. Oil Type: Auto Trak II. Volume: 1.05 Quart.

What causes foamy fluid in power steering system?

Foamy fluid is an indication of air getting into the system. Step 2: Add power steering fluid if the level is low. Check the owner’s or service manual for the type of fluid before adding anything. Step 3: Find the bleed valve and apply some penetrating oil.

What to do if power steering fluid is low?

Check the fluid hot or cold, depending on what the manual says. Turn the steering wheel a few times and take a reading. Foamy fluid is an indication of air getting into the system. Step 2: Add power steering fluid if the level is low. Check the owner’s or service manual for the type of fluid before adding anything.

What kind of lube does a Dodge Ram use?

Mopar Synthetic 75W-85 Trans Lube (NV4500 manual) Mopar ATF+4 (G238/G56 manual) Transmission Fluid Capacity 5.5 quarts (2WD 45RFE/545RFE/68RFE auto) (with filter/fluid change) 6.5 quarts (4WD 45RFE/545RFE/68RFE auto)

What happens when you change the steering fluid in a Dodge Ram?

If the fluid gets too dirty, the consistency will change, causing the pump to work harder, resulting in the squealing noise. The good news is all you have to do is flush the power steering fluid to get the truck back to operating smoothly. Use the following instructions listed here to replace the power steering fluid in your Dodge Ram.

When to change power steering pump in Dodge Ram 1500?

This article applies to the Dodge Ram 1500 (1994-2008). If you’re the DIY type of person who likes to keep your vehicle running like new, checking the fluid in your power steering pump reservoir is basic stuff. Changing it, if needed, is a no-brainer process that’ll pay off in the long run with the extended life of your Ram.

Why is my power steering fluid not working?

The problem may not be as bad as it sounds. I n fact, in most cases you just need to check your power steering fluid to get an idea of what is wrong. The power steering system in your Dodge Ram uses a special fluid that allows the hydraulic system to operate.

What kind of power steering fluid do I Need?

Grab the ATF+4 fluid and pour it into the reservoir; the system will take approximately 2 quarts. Turn the truck on and turn the steering wheel; doing so will help remove any remaining air from the system. Check the fluid and top it off if necessary. Figure 7. Type of power steering fluid you need. Figure 8.

Which is the best oil for power steering?

This synthetic oil power steering fluid is compatible with any OEM hydraulic power steering system and is touted as having the ability to outperform many other OEM and third-party fluids. With that said, this fluid works better on synthetic pumps than non-synthetic pumps.

What kind of fluid does a ram truck use?

I believe, if you’ll check your owners manual, it specifies power steering fluid. Yep,on Page 867 on 2016 Ram Truck it says Power Steering Reservoir – 2500/3500 Models we recommend you use MOPAR Power Steering Fluid +4 or MOPAR ATF+4 Automatic Transmission Fluid.

What happens if you mix power steering fluid with transmission fluid?

The wrong fluid, or fluid mix, in the wrong system can cause severe damage and may render your power steering system inoperable. If your vehicle doesn’t use a fluid called “power steering fluid”, the other most commonly used working fluid is automatic transmission fluid.

Do you have to use ATF 4 + power steering fluid?

you have to use atf 4+. is the fluid in there clear right now? if its not red then they used power steering fluid which will ruin the system. 99% of off the shelf generic PS fluid, clear or red, will mix with ATF.

When to flush and replace power steering fluid?

Fluid specs may have changed since then. Is there a newer forum sticky on 2013 + trucks for service info?? Hope this helps some. Power Steering Service: (3500) Flush and replace power steering fluid at 97,500 Miles (157,000 km) or 78 Months. (2500) Flush and replace power steering fluid at 105,000 Miles (168,000 km) or 84 Months.

What kind of power steering fluid does Dodge use?