Where is the battery on a Mercedes Sprinter?
Where is the battery on a Mercedes Sprinter?
First, know that the Mercedes Benz Sprinter has two, very different batteries on-board – Starting & House Batteries The primary starting battery categorized as the chassis battery is located under the drivers floorboard or under the hood in some models and is a group size 49 battery.
How many batteries are in a Sprinter van?
If yes, how many? Typically, the average Sprinter van house battery will be two 12 volt 100 ah or higher batteries wired in parallel. But we recommend upgrading to two or four 6 volt deep cycle AGM batteries wired in series (for two) or series and parallel (for four).
Is the AGM battery in a sprinter maintenance free?
And best of all, the sealed batteries are maintenance free! In addition, God forbid, but if the van turned over, the AGM batteries will not be spilling sulfuric acid inside your living station. Q: AGM or GEL, Which one do I select?
Where can I buy a new Sprinter van?
Post Sprinter Vans for sale here. Vans must be driveable, otherwise, they go to the parts section here. Post Sprinter Parts for sale here, including vans that are not driveable. OMG!!! Can I get a decent price on a van already???
What kind of battery does a Sprinter van have?
WARNING #2 – these photos are from a 2015 NCV3 2500 Sprinter van with a factory-installed aux battery. Your van may be very different.
How does the aux battery in a sprinter work?
This second battery should be of exactly the same type as your starter battery (the one under the driver’s feet). The aux battery works by connecting to the alternator and the starter/engine battery whenever the engine is running, and then disconnecting whenever the engine is off.
And best of all, the sealed batteries are maintenance free! In addition, God forbid, but if the van turned over, the AGM batteries will not be spilling sulfuric acid inside your living station. Q: AGM or GEL, Which one do I select?
How can I reset the battery on my Sprinter van?
CAREFUL: undo the wires that thread through the seat base cover board and up to the seat before you remove the board. Reconnect them before you reconnect the battery or turn the key in the ignition. If you don’t you’ll get error codes that can only be reset with a diagnostic tool.
