How do you use an automatic fuel pump?
How do you use an automatic fuel pump?
Put the gas nozzle into the gas tank. Pull it down slightly until it’s secure. Pull up on the nozzle’s trigger, and lock it into place. It will automatically shut off when the tank is full. Carefully remove the nozzle when the machine stops pumping gas, to avoid spilling.
Do you turn the car off when getting gas?
Make sure you put your vehicle in park and turn the engine off before pumping gas. You should also switch off any auxiliary 12-volt power sources such as phone chargers and cigarette lighters because, while rare, they can be a potential igniter of a fuel fire.
Why does my fuel pump not prime with the key on?
Fuel pump doesn’t prime with key on. I’ve been trying to figure this out for a couple days now. My 01 Tiburon wouldn’t start the other day. It would crank, but wouldn’t fire. When I turn the key to the “on” position, the fuel pump doesn’t kick on.
Why does my fuel pump only run for a few seconds?
This sound is the electric fuel pump trying to prime the fuel system. It will only run for a few seconds and then shut off. If you are not sure you could hear it or if there is noise outside; you may have to try it several times. Turn the key on and wait then turn it off.
Where to check for no start fuel pump?
The first thing you want to do is check the fuse panel to see if the fuse is blown. If your car has two fuse panels than the one in the engine compartment; should be the correct one to check. The fuse panel or circuit box is usually located near the battery; and is a small black box with a removable lid.
Why is the fuel pump relay not closing?
If jumping the fuel pump relay makes the pump run, and if the relay tests good. Then you need to determine why the ECM is not telling the relay to close. Start by testing continuity back to the ECM. Here is the electrical diagram for the 01 Tib Fuel Pump Relay
How long does it take for the fuel pump to start after turning on the engine?
It will stay there (usually) for a good 24 hours (Note: 24 hours is an approximation. It will take longer in some cars and less time in others for the fuel pressure to bleed off back into the fuel tank). When you turn the key on, the fuel pump will start running.
Fuel pump doesn’t prime with key on. I’ve been trying to figure this out for a couple days now. My 01 Tiburon wouldn’t start the other day. It would crank, but wouldn’t fire. When I turn the key to the “on” position, the fuel pump doesn’t kick on.
What to do if your fuel pump won’t start?
Ugh…..I hate chasing down electrical problems. If jumping the fuel pump relay makes the pump run, and if the relay tests good. Then you need to determine why the ECM is not telling the relay to close. Start by testing continuity back to the ECM.
How to set up a fuel pump relay?
1 Set your digital multimeter to the lowest range on the Ohms scale or set it to ‘continuity’. 2 Connect one lead to one of the power circuit pins, and connect the other lead to the other power terminal. 3 Your meter should read infinite resistance.
