Is there a way to tune a hemi Ram?

Is there a way to tune a hemi Ram?

In the ‘90s I achieved this effect by forcing the engine, which, accordingly, decreased MPG`s. Modern cars, however, can be modified without mechanical changes in engine design by implementing a tuning for cars.

What causes hard shifting on a Dodge Ram 1500?

A transmission pan costs about $99, and the transmission fluid is priced at $75 Another culprit that causes hard shifting is a faulty transmission sensor. If you need to replace the sensor, you should expect to pay $100 for the transmission sensor.

Why is my Dodge Ram transmission not working?

No heat One of the leading causes for Dodge Ram transmission problems can be a heat a problem. But why is it? If the coolant has some dirt residue—all the dirt will eventually stop the flow of the coolant. While this is not a permanent fix, this will allow you to drive for quite some time.

What are the warning lights on a ram?

The following are warning lights and indicators found in vehicles built by Ram. Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray), but there are over 70 of them so be patient!

Can a 5.7 Hemi engine crank no start?

If the voltage returns to 5V while the coolant temp sensor is disconnected then you know the sensor is shorted. Try disconnecting the coolant temp sensor and cranking the engine to see if you have spark at one of the coils. For your question about the extra ground, yes, it is always good to have a soild, reliable ground.

What to do if your Dodge Ram wont start?

Checked all fuses and relays all good. Have P0685 and P0688. Both lead to ASD issue. Tested control circuit from relay to ecm and got .3 ohms. Relay powers up when key first turned on. Have 12 vdc at coils and injectors when jumping relay still won’t start. Have replaced both cam and crank sensors and no change.

Is the 5 V signal good on a Dodge Ram?

Have 5 v signal at both cam and crank, ground is good and getting signal back to ecm. Not sure what to check next before having to replace ecm. Checked all fuses and relays all good. Have P0685 and P0688.

What kind of noise does a 4WD Dodge Ram make?

First noise is the 4 Auto, then 4 high, then 4 low. then it goes back. I have the NVG case, you may have the Borg Warner case but they should produce similar shifting patterns. If your encoder motor is not operational, it is a pretty easy fix. I just ordered the part off amazon and I believe 3 bolts and a plug and it was out.