What kind of Fuse does a sprinter have?
What kind of Fuse does a sprinter have?
No. Consumer Fuse rating 8 Anti-theftalarmsystem (ATA)/beacon/beacon withsiren 15A 9 Additionalturnsignal module 10A FuseblockF55/2 No. Consumer Fuse rating 10 Radio1DIN Radio2DIN 15A 20A 11 Mobilephone/tacho- graph/additional recorder4/navigation cradle6
Why do I have intermittent power in my sprinter?
Sometimes due to a weak moulding, the threaded insert in the column plastic fails, preventing the secure fastening of the fuse board at its top edge. The best cure for this is to remove the insert with careful use of a screwdriver and prize it out, then using a strong tie-wrap as pictured to secure the whole assembly.
Why is my Turn indicator not working on my Mercedes Sprinter?
More often than not the number one cause of indicator problems on the Mercedes Sprinter range is due to the failure of a small control relay located on the lower edge of the fuse board on the steering column.
Can a blown fuse be switched back on?
The breakers reset and can be “switched back on”–so there is no need to replace anything. Much of the time, it’s technically inaccurate to refer to a “blown fuse,” so in this article, we’ll offer you some new concepts and vocabulary to describe your various electrical concerns.
Where are the fuses located on a Mercedes Sprinter?
Additional fuses and relays for the items of optional equipment are located in the fuse box under the driver’s seat and in its seat base. The fuse box is located in the footwell on the left-hand side of the vehicle. *1 – Vehicles with code MI6/MH3/XM0.
What to do if a Mercedes Benz fuse blows?
Blown fuses must be replaced with fuses of the same rating, which you can recognize by the color and value. The fuse ratings are listed in the fuse allocation chart. If a newly inserted fuse also blows, have the cause traced and rectified at a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center.
Where is the short on a riding mower fuse?
If the multimeter measures no voltage, skip to the section for checking the circuit when you turn the key to the run position. If the multimeter measures voltage, the short is in the red wire between the fuse holder and the ignition switch or in the ignition switch itself.
Why did the fuse blow on my Tractor?
If the new fuse didn’t blow, an intermittent short caused the original blown fuse. An intermittent short can be difficult to find. Try wiggling each wire harness in the tractor back and forth and then repeat the test using the fuse. If you wiggle a harness and the fuse blows, then that harness contains a shorted wire.
