Can You Hot Wire a fuel pump through a G Terminal?

Yes I changed the fuel pump relay and checked the fuse. Neither appeared to be bad and the old relay clicked and worked if I jumped the G terminal. My question is can I hot wire the fuel pump through the G terminal using a toggle switch and not cause any damage to anything?

Is there any power to the fuel pump?

I have no power to the fuel pump on a 2002 silverado 1500 5.3. Check the grey wire with the key getting switched on. Still no power. , GM MASTER/WORLD CLASS.

Where is the fuse for the fuel pump?

ASE MASTER replied 9 years ago Check the ECM B fuse located in the under hood fuse box. This is the power supply to the fuel pump and relay. If the fuse is bad, then replace it to see if the fuel pump has power. The truck may start if the fuse is replaced but you will still need to replace the pump.

How many volts do you need to flip the switch on a fuel pump?

This must be over 10 volts to flip the switch in the relay. This will confirm whether or not the ECM is telling the fuel pump to run. 2. Check for continuity from the tan/white wire at the relay to the fuel pump. This will determine if power can get from the relay to the fuel pump.

How do you re-wire a fuel pump?

The steps of re-wiring your fuel pump are to first get to your fuel pumps wiring. At the wiring you need to find the 12v supply wire from the ECU to the fuel pump. Once that wire has been found cut that wire so that you now have half of that wiring running to the fuel pump, and the other half running to the factory ECU.

Is there no power to the fuel pump?

No power to the fuel pump and the fuel relay is not getti… Q: No power to the fuel pump and the fuel relay is not getting power. My car has 190000 miles.

Why is the fuel pump and relay not working?

The ignition circuit, which includes the ignition switch, controls power to many components, including the fuel pump and relay. If there is an issue with the switch or the circuit, perhaps a wiring problem, then power to the fuel system may be cut off.

How to install new GM wire harness on fuel pump module?

If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred. Please try again later. (Playback ID: WfYJuntPOgNiQAf9)

How to tell if ECM is telling fuel pump to run?

With the key in the run position, check for voltage at the Dk Green/White wire at the relay. This must be over 10 volts to flip the switch in the relay. This will confirm whether or not the ECM is telling the fuel pump to run. 2. Check for continuity from the tan/white wire at the relay to the fuel pump.

How can I tell if my fuel pump is running?

1. With the key in the run position, check for voltage at the Dk Green/White wire at the relay. This must be over 10 volts to flip the switch in the relay. This will confirm whether or not the ECM is telling the fuel pump to run. 2. Check for continuity from the tan/white wire at the relay to the fuel pump.

How can I tell if my fuel pump has no power?

There should be 3 power terminals. The relay only runs for 2 seconds after you turn the key on. So you have just a little time to test it. That will tell if you have power going from the relay and then the issue is down stream from the relay. You can also check it at that connector. Was this answer helpful?

Can You Hot Wire a fuel pump through a G Terminal?