Which is Dana 60 front axle parts diagram?

Which is Dana 60 front axle parts diagram?

Description : Pirate4X4 – Extreme Four Wheel Drive within Dana 60 Front Axle Parts Diagram, image size 1536 X 2048 px, and to view image details please click the image. Actually, we also have been remarked that dana 60 front axle parts diagram is being just about the most popular subject at this time.

What do you need to know about the Dana 60?

Description: DANA 60 STUDS : EACH STUD COMES WITH CONICAL NUT. SOLD INDIVIDUALLY AS ONE STUD AND NUT. 180,000 PSI tensile strength Description: The ECGS Dana 60 High Pinion Front Axle features the highest quality parts available on the market. Using the bulletproof Dana 60 High Pinion center section we build the housing to your… More Details »

How big are the seals on a Dana 60?

Description: Seals-it Axle Seals Size 2 for Dana 60 and Tubes 2-1/8″ to 2-1/4″. Two Required Per Axle Description: Seals-it Axle Seals Size 2 for Dana 60 and Tubes 2-1/2″ to 2-3/4″. Two Required Per Axle

When did the Chrysler Dana 60 come out?

Chrysler began using the Dana 60 in 1966 big-block B-body passenger cars (specifically the 426 Hemi and the 440 engines with a 4-speed transmission). The Dana 60 is a Salisbury-type rear-end, meaning the differential carrier removes from the rear of the axle instead of the front.

Is the Dana 60 front axle a manual axle?

Dana 60 Manual Front axle Part 1 of 2 – Dana 60 Front Axle AXLE MAINTENANCE MANUAL MODEL FRONT AND REAR CARRIER TYPE SPICER AXLE DIVISION DANA DANA CORPORATION WAYNE, INDIANA INDEX LUBRICATION IDENTIFICATION OF SERVICE TOOLS AXLE IDENTIFICATION .

What was the difference between the Dana 60 and 61?

To allow for the different gearing, the Dana 61 had a greater pinion offset. This offset meant that a different carrier and a different ring and pinion had to be used.

How to remove drive flange from Dana 60?

Remove drive flange and gasket. Discard gasket. Replace with new one at time of assembly. To free flange from hub, tap lightly With a rawhide h ammer. FRONT AXLE Figure 9 Remove outer ltxknut, lockring, and inner wheel bearing adjusting nut. Tool: Wheel Wrench. Figure 10 Remove drum assembly. Outer wheel bearing Will slide out as drum is removed.

What kind of brakes does a Ford Dana 60 have?

Ford versions are driver’s side differential drop, reverse-cut gears, and kingpin knuckles up to 1991. The later axles have ball joints. Ford Dana 60 axles mostly feature 35 spline inner axle shafts, but some are 30 spline. Larger brakes and 35 spline outer shafts were made standard in 2005.