What kind of transfer case does a Jeep Wrangler use?
What kind of transfer case does a Jeep Wrangler use?
The new TJ Wrangler continues to use the NP231, but the NP231 used in the TJ has a different tail housing that allows the removal of the drive shaft with out losing transfer case fluid. Both versions of the NP231 used in the Wranglers have an over all length that is long for a short wheel base vehicle.
What’s the axle ratio on a Dodge Dakota?
* Lock Right has a Locker for the 8.25 axle. Ratios: Dakotas came with 3.21, 3.55, or 3.90. The 3.90 is an option on all.
When to lock the 3rd differential in a 4 wheel drive car?
The 3rd differential or center diff can be locked by the driver when low range is selected or 4H is engaged by the driver which locks the front and rear differentials together.
How many gears are in the 242 transfer case?
The important variations to look for in the 242 transfer case are in the input gear. The 242 comes in 21 spline and 23 spline versions with long, medium (rare) and short variations. We have documented these gears here.
What does a transfer case do on a Dodge Ram?
This article applies to the 2nd Generation Dodge Ram (1994-2001). A transfer case controls the front and rear axles of 4WD trucks, and inside of the case are a several moving components such as gears and chains.
Where is the transfer case on a 4WD car?
As previously mentioned, the transfer case is found on vehicles with AWD or 4WD capability and is integral in allowing drivers to switch to these modes of operation. A typical 4WD transfer case is found at the rear of the transmission. It is powered by the transmission output shaft and operates much like a secondary transmission.
Can a bad transfer case output shaft seal fail?
Over time the transfer case output shaft seal can fail, and when it does, will display a few symptoms that will alert the driver that a problem with this system exists. Noted below are a few of the common side effects of a damaged transfer case output shaft seal that should be replaced. 1. Difficulty shifting gears
How do you remove transmission seal on Dodge Ram?
Use a seal puller to remove the transmission output seal. To prevent gouging the aluminum when applying leverage, place a piece of cardboard in between the puller and the transmission. Figure 6. Use a seal puller to remove the transmission output seal. Use a paint pen to mark the orientation of the retaining plate on the old transfer case.
