How do you replace a front axle shaft?
How do you replace a front axle shaft?
Using a torch, heat the flange of the shaft to loosen the u-joint caps. Place a 3/4″ socket on the top cap of the u-joint, and tap out joint with a hammer. Pounding too hard on the flanges could damage the shaft and prevent the new u-joints from fitting properly.
How to replace front axle on Dana 44?
Front Axle Shaft U-joint Replacement For Dana 44 axle with Warn manual locking hubs – 1978 F150 4×4 Place drain pan under front differential and loosen (10) 1/2″ bolts holding differential cover to housing. Loosen cover and allow fluid to drain. Remove bolts and cover and inspect gears for wear. Remove lug nuts from wheel and remove wheel.
How to replace a front axle on a Dodge Ram?
This video covers how to replace a front axle universal joint and a hub or wheel bearing in a 1999 dodge ram 1500 4 wheel drive. Very similar to a 2500. It may be less damaging to loosen the hub bolts and tap on them with a hammer vs the method shown in this vid. Loading…
How do you remove a front differential cover?
Place drain pan under front differential and loosen (10) 1/2″ bolts holding differential cover to housing. Loosen cover and allow fluid to drain. Remove bolts and cover and inspect gears for wear.
How to change front axle U-joints in Dodge?
If there is play in the U-joint, replacement is required. Loosen the lug nuts on the front wheels of your Dodge with a lug wrench. Raise the truck using a jack and support the front end on a set of jack stands. Remove the tires and wheels, setting them aside for now.
How to replace universal joint on Dodge Ram 3500?
How it’s done: 1 Jack up the back side of the car. 2 Remove the drive shaft. 3 Remove and replace the U-joints.
How long does it take to replace a front drive axle?
These are usually called front drive axle u-joints. If a front drive axle u-joint needs replaced, the labor is 2.3 hours, involving removing the front brakes and front hub to pull the axle and allow the u-joint to be replaced on the bench.
What should I do if I need to replace my universal joint?
Jack up the back side of the car. Remove the drive shaft. Remove and replace the U-joints. A mechanic should lubricate the U-joints during regular maintenance service. Doing so will greatly improve the life of the U-joints. What common symptoms indicate you may need to replace the Universal Joint (U-joint)?
