Where is the ECM located on a Chevy?

A repair handbook will also tell you, in detail, how to remedy problems with the ECM, Consider taking the vehicle to the a General Motors approved mechanic. The ECM is a single a component, located behind the dash on the passenger’s side. Repair options are limited.

What does the code 86 mean on a Chevy ECM?

Count the flash codes and record them onto a sheet of paper. The check engine light will flash the codes at you, in a series of long and short pulses of light. For example, General Motor’s code 86 will appear as eight long flashes, followed six shorter flashes. There will be a dark, silent pause between coding sets.

Where is the jumper wire on a Chevy ALDL?

Run a length of jumper wire between the ALDL’s “A” and “B” ports. These two slots are on the ALDL’s top row, and all the way to the right, at the end. The “A” and “B” ports are also side by side. Turn the Chevy’s electrical system on, but leave the engine off.

Where to find the ALDL on a Chevy?

Troubleshooting the module requires the same proceedure as pulling the vehicle’s fault codes. Open your Chevrolet’s driver’s side door and find the Assembly Line Data Link. The ALDL, for all General Motors vehicles, will be found directly below the steering column, in the center of the dash’s underside.

Where is the assembly line data link on a Chevy?

Open your Chevrolet’s driver’s side door and find the Assembly Line Data Link. The ALDL, for all General Motors vehicles, will be found directly below the steering column, in the center of the dash’s underside. Run a length of jumper wire between the ALDL’s “A” and “B” ports.

Where is the jumper wire on a Chevy ECM?

The ALDL, for all General Motors vehicles, will be found directly below the steering column, in the center of the dash’s underside. Run a length of jumper wire between the ALDL’s “A” and “B” ports. These two slots are on the ALDL’s top row, and all the way to the right, at the end.

What is the fuse box diagram for a Chevy Cavalier?

Here you will find fuse box diagrams of Chevrolet Cavalier 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004 and 2005, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

What kind of computer does a Chevy ECM use?

Chevrolet vehicles manufactured before 1996 use an internal computer called an Electronic Control Module, and it oversees the automated engine diagnostic routines. A Chevrolet’s ECM can sense problems as they present themselves, and it keeps an ongoing record.

Where is the ECM on a Chevy ALDL?

What causes the ECM in a car to fail?

The most common source of ECM failure is in one of the wiring harnesses. If the wires to the transmission or fuel injectors become corroded, they can lose conductivity, leading to a failure. Fortunately, these issues can usually be resolved by replacing the corroded wires. If one of the wires shorts out to the frame, the ECM may fail entirely.

What to do if your ECM has been reset?

The ECM has now been reset. If you find it difficult to keep the battery cable from touching the negative terminal, use a non-conductive material such as rubber as a barrier. The negative cable is the black one marked with a minus sign. Do not allow the negative cable to touch the positive one, or allow your tool to bridge the two terminals.