How to calibrate a Dodge Challenger sun roof?
How to calibrate a Dodge Challenger sun roof?
This procedure has worked for JGC and Charger/300/Challenger/Magnum owners. Its for when the sunroof is closing too high or low. Steps 1-6 are for using a Starscan thus starting with #7. 7. Place the ignition switch in RUN position. 8. Close all of the doors. 9. Press and release the vent switch (sunroof should move to vent position). 10.
Is there a problem with the sun roof calibration?
Once the sunroof stops moving the calibration is complete. If you are still having issues, you could possibly have a sensor that has died. When I close the sunroof from the Vent positions it seems to be higher along the rear edges than when I close the sunroof from any Open position.
What to do if the sunroof does not work?
NOTE: If at any point during the following procedure the sunroof does not respond as expected, restart the procedure at Step 1. 1) Depress and hold the CLOSE push button of the sunroof switch until the sliding glass panel is fully closed. 2) Continue to hold the CLOSE push button of the sunroof switch.
Why is the sunroof higher than the roof?
If you are still having issues, you could possibly have a sensor that has died. When I close the sunroof from the Vent positions it seems to be higher along the rear edges than when I close the sunroof from any Open position. So I try to open the sunroof and then close it so it will be in the position where the rear edge is more flush to the roof.
How do you change the sunroof on a Dodge Ram?
2. Press the vent button on the power sunroof switch and hold until the sunroof glass panel has moved to the full vent position and the motor movement has stopped for at least 1 second. 3. Press the close switch on the power sunroof switch and hold for a moment (at least 100ms) and release.
This procedure has worked for JGC and Charger/300/Challenger/Magnum owners. Its for when the sunroof is closing too high or low. Steps 1-6 are for using a Starscan thus starting with #7. 7. Place the ignition switch in RUN position. 8. Close all of the doors. 9. Press and release the vent switch (sunroof should move to vent position). 10.
How do you calibrate a Chrysler sunroof?
Press the vent button on the power sunroof switch and hold until the sunroof glass panel has moved to the full vent position and the motor movement has stopped for at least 1 second. 3. Press the close switch on the power sunroof switch and hold for a moment (at least 100ms) and release.
Once the sunroof stops moving the calibration is complete. If you are still having issues, you could possibly have a sensor that has died. When I close the sunroof from the Vent positions it seems to be higher along the rear edges than when I close the sunroof from any Open position.
