When to replace the EGR on a hemi?
When to replace the EGR on a hemi?
This reading checks the health of the coil that activates the EGR. If it reads an open circuit (not likely) or O ohms (shorted out), the EGR will need replacement, stop here and go to the auto parts. If the reading is good proceed with the rest of the repair (if you’re so inclined). This part is for the more mechanical folks.
Why is my EGR valve not working right?
There are several EGR codes that are related to the fact that the EGR valve cannot respond fast enough for the PCM to be satisfied that it is working right. The code came in at 8:30 pm so I worked on “repairing” the EGR till 10 pm. This is a week later and so far, so good.
What kind of valve does a Dodge Ram have?
(Playback ID: 6aYa09xnMVNJoRg1) An error occurred while retrieving sharing information. Please try again later.
How much does a Dodge Ram 1500 EGR valve cost?
Your Dodge Ram 1500 will be happy to know that the search for the right EGR Valve products you’ve been looking for is over! Advance Auto Parts has 13 different EGR Valve for your vehicle, ready for shipping or in-store pick up. The best part is, our Dodge Ram 1500 EGR Valve products start from as little as $46.99.
Where is the EGR valve on a Ford truck?
The EGR valve is located on the left side (facing the front of the truck) of the engine block just after the spark plugs and looks like this. I found it much easier to get to the valve after removing the airbox. Remove the cover of the airbox by unsnapping the clips on the outer edges. Be careful to hold on to the clips.
How to deal with a bad EGR valve?
There are many ways to deal with a bad EGR valve found on Google, some say to clean it, some say to replace it. I had to do both. First remove the negative battery cable with a 10mm socket with extension and set it aside so it is not touching any metal part of the truck.
How do you replace the EGR valve on a hemi?
There are two bolts holding the exhaust pipe to the lower part of the EGR valve, the bolts can easily be removed with a 8mm socket with an extension. If they are stuck use some PR Blaster on them, mine came off easily. Make sure to hold onto the gasket that is between the pipe and the valve when removing the pipe.
