How do you replace a speed sensor on a Harley?

Pull the speed sensor straight out of the engine crankcase. Install a new speed sensor into the engine crankcase. Screw the sensor retaining bolt into place and tighten it to 90 inch-pounds, using a torque wrench. Plug in the speed sensor connector. Push the Maxi-fuse into the fuse holder, then reinstall the fuse holder cover.

How to replace a faulty transmission speed sensor?

Follow these procedures for replacing a faulty vehicle speed sensor (VSS). The same removal and installation instructions apply for both the input and output speed sensor. CAUTION: When replacing the new speed sensor be sure the O-ring on the new sensor is correctly fitted on the sensor before installation.

How much does it cost to replace a speed sensor?

After an OBD II scan you learn that your input or output vehicle speed sensor (VSS) has malfunctioned and needs to be replaced. You can take your car to the repair shop or dealership and spend between $100 and $250 or more to have one speed sensor replaced or you can replace the sensor yourself for a fraction of the cost.

How to replace the speed sensor on a Softail?

Harley Davidson Softail: How to Replace Speed Sensor. 1 Step 1 – Locate the speed sensor. If you have never worked on a Harley before, you might assume the speed sensor is on the front or back wheel, but 2 Step 2 – Remove splash guard. 3 Step 5 – Install new speed sensor.

How much does it cost to install a speed sensor?

A sensor that rarely ever fails, but if it your vehicle is equipped with one of these and does fail expect the speedometer to fluctuate and the transmission to shift erratically. The cost of the part was 74 dollars, and took 30 minutes to install.

How to replace speed sensor on Harley Davidson?

Installation is the reverse of removal. You may want to wipe some oil on the O-ring of the new part to make is easier to fit it in the hole. Press firmly until it pops in, don’t expect the Allen bolt to do the work for you. Replace the electrical components and tighten the three bolts.

How do you replace a speed sensor on a Harley?