Where can I find the solenoid A and B test?
Where can I find the solenoid A and B test?
You can find this tutorial in Spanish here: Cómo Probar los Solenoides de Cambio A y B (GM 4.3L, 5.0L, 5.7L) (at: autotecnico-online.com ). TIP 1: Before removing the transmission oil pan, read the section: Before You Remove The Trans. Oil Pan.
What are the diagnostic codes for Shift Solenoid?
The most common one is the check engine light will be on with one of the following diagnostic trouble codes: P0751 1-2 Shift Solenoid Valve Performance (Shift Solenoid A Performance) P0753 1-2 Shift Solenoid Valve Electrical (Shift Solenoid A Electrical) P0756 2-3 Shift Solenoid Valve Performance (Shift Solenoid B Performance)
When to know if you have a solenoid problem?
The most important thing to remember, when trying to decide if you have a solenoid issue or internal transmission damage (causing the transmission to stay in Limp-In mode) is two very important things: You’ll have a specific transmission solenoid trouble code stored in the PCM’s memory.
What is the diagnostic code for a Chevy check engine light?
Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Chevy diagnostic trouble codes. Manufacturer Specific Codes P0342Camshaft Position Sensor A Bank 1 Low Input – Related Information P1031HO2S Heater Current Monitor Control Circuit Sensors 1
What is the oxygen sensor code for a Chevy?
P1137HO2S Bank 1 Sensor 2 Lean Or Low Voltage – Read Our Article On Oxygen Sensor CodesFor Help With This Chevy Trouble Code P1138HO2S Bank 1 Sensor 2 Rich Or High Voltage – Read Our Article On Oxygen Sensor CodesFor Help With This Chevy Check Engine Light Code
Where do I find the trouble code on my Chevy?
These are listed in numerical order for easy searching. When retrieving Chevy trouble codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.