Where is the fuel pump on a Pontiac Grand Am?

Check in the engine compartment fuse box, it should be near the battery under the hood. The cover should be pretty easy to remove. The fuel pump should be connected through a fuse in slot 48. If that fuse looks good, then you may want to check the fuel pump relay (also inside the engine compartment fuse box).

Why is the starter not turning on my Pontiac Grand Am?

If you can hear the starter motor turning but the engine isn’t turning (look at the belt) then the starter may not be engaging (in your car I believe this means that you must replace the whole starter). You can remove and test your starter to confirm whether or not the solenoid is engaging the starter.

What kind of car is the Pontiac Grand Am?

The Pontiac Grand Am is a mid-size size (and later compact) car produced by Pontiac. The 1999-2005 generation is the final generation of the Pontiac Grand Am. 2003 Grand Am will not start.

Why is my fuel pump reset button not working?

Anything from factory security system locking you out, bad fuse/relay, clogged fuel filter,faulty fuel pump, oil sending unit/crank sensor failure, clogged catalytic converter, failing electronic ignition, ECM/PCM,etc.,etc. As a first step best to see if there are any stored trouble codes that could point directly to the fault.

How can I relieve the pressure on the fuel tank?

Remove the negative battery cable from the battery terminal. Relieve the fuel system pressure by removing the fuel tank cap. Locate the fuel pressure port at the end of the fuel rail–it is covered by a black twist-off cap. Remove the cap and place towels around the end of the rail.

Where is the fuse block located on a Pontiac Grand Am?

The engine compartment fuse block is located on the driver’s side of the vehicle, near the battery. WARNING: Terminal and harness assignments for individual connectors will vary depending on vehicle equipment level, model, and market.

How do you remove pressure from fuel rail?

Locate the fuel pressure port at the end of the fuel rail–it is covered by a black twist-off cap. Remove the cap and place towels around the end of the rail. Touch the port with a small tool to eliminate any pressure in the system. Replace the cap when finished, relieving the pressure.

How do you install a new fuel pump?

Install a new O-ring seal onto the new fuel pump and install the new fuel pump into the tank. Make sure to align the small notch in the fuel tank with the tab on the new fuel pump. Connect the wiring harness to the fuel pump. Replace the fuel tank by lifting the tank up and fastening the strap bolts.

Why is there no fuel in the tank?

I replaced the fuel pump, fuel filter, and tank selector switch, but still no fuel. Other possible causes of your lack of fuel issue could be the fuel injectors or an electrical problem. If the fuel injector fuse (s) are blown due to a wiring issue, this may cause your problem.

What happens if you don’t change your fuel filter?

WHAT HAPPENS IF YOU DON T CHANGE YOUR FUEL FILTER 1 Your engine will not perform well: anytime your fuel filter gets clogged, it has the ability to reduce the flow and… 2 Your vehicle’s parts might damage: note that because of its abrasive action, dirt and contaminants in the fuel can speed… More

How do you replace a fuel filter on a Pontiac Grand Prix?

Tighten the fuel line to the fuel filter with the use of an adjustable wrench. Ensure the fuel line is attached to the fuel filter tightly. Secure the fuel filter to the mounting bracket with a flathead screwdriver. The mounting bracket should come together around the fuel filter. Make sure the fuel filter is snugly secured by the mounting bracket.

The Pontiac Grand Am is a mid-size size (and later compact) car produced by Pontiac. The 1999-2005 generation is the final generation of the Pontiac Grand Am. 2003 Grand Am will not start.

How do you re pressurize a fuel line?

Re-pressurize the fuel system by shutting the valve and turning the ignition to the “on” position (the position just before the crank position where you attempt to start the vehicle). You will hear the fuel pump prime the system.

Where does the fuel line go in a car?

The fuel line carries the fuel from the fuel tank to the fuel injection system in your vehicle. Fuel lines are under high pressure. Whenever you work on them, you’ll need to relieve that pressure using something called a Schraeder valve, which is located on the fuel rail in most vehicles.

How do I pressurize my fuel system after replacing the filter?

Remove the fuel lines from the fuel filter if the filter is being replaced, otherwise leave them loosened until your maintenance work is complete. Tighten the fuel lines in a clockwise direction once your maintenance work has been completed and you wish to pressurize the fuel system again. Tighten the fuel filler cap.

When to remove fuel lines from fuel filter?

Can you change the fuel filter on a Ford truck?

The fuel system in your vehicle is under intense pressure. If you were to change the fuel filter in your Ford without relieving the fuel system pressure, you would risk a severe injury. There are two methods of depressurizing a Ford fuel line. The first is primarily used on Ford trucks and the second is primarily used on Ford cars.

When did the last Pontiac Grand Prix fuel pump come out?

The last generation was produced from 2004 to 2008 and had a 3.8 L, 3.8 L supercharged or a 5.3 L engine. Prepare your vehicle for fuel pump servicing. Relieve the fuel system pressure and drain the fuel tank until it is one-quarter full. Disconnect the negative battery cable with a socket wrench.

How do you get a fuel pump out of a gas tank?

Twist off the cap at the top of the gas tank with a counterclockwise movement using a large set of channel locks. Place the cap to the side and discard the O-ring. Lift up on the fuel pump assembly to pull it out of the tank. You may have to tilt the assembly to pull it out comfortably.

Where is the fuel pump on a Mercury Grand Marquis?

Removing the fuel pump in a Mercury Grand Marquis can be tricky as the tank sits below the vehicle and has an oblong shape. Once the straps are removed and out of the way, the fuel tank will come straight down.

How to check fuel pressure regulator on a Pontiac Grand Am?

Attach the vacuum hose to the port on the fuel pressure regulator. Plug in the electrical connection for the fuel pump near the fuel tank on 2.4-liter models. On 2.2-liter and V-6 models, replace the cap on the end of the fuel rail. “Haynes Repair Manual: Pontiac Grand Am 1999 thru 2004”; John H. Haynes and Jay Storer; 2005

Where is the fuel pump located on a car?

On most modern vehicles, an electronic pump located in the tank pumps the fuel directly from the tank through the rest of the system. It is activated as soon as you turn the key to create fuel pressure for startup. If you try to start your car and it won’t fire, listen near your fuel tank when you turn the key on.

Where is the fuel tank cap on a Pontiac Grand?

Plug in the electrical connection for the fuel pump near the fuel tank on 2.4-liter models. On 2.2-liter and V-6 models, replace the cap on the end of the fuel rail. Eric Grosso has been a journalist since 2002, working as a staff reporter covering government events, school districts, sporting events and entertainment acts.

Where is the fuse box on a Pontiac Grand Am?

Cigar lighter (power outlet) fuse in the Pontiac Grand Am is the fuse #34 in the Engine compartment fuse box. There are two fuse blocks, which are located on the right and left in the dashboard, behind the covers. How to check the fuses? How to replace a blown fuse? Why do car fuses blow?

When did the Pontiac Grand Am 5th generation come out?

In this article, we consider the fifth-generation Pontiac Grand Am, produced from 1999 to 2005. Here you will find fuse box diagrams of Pontiac Grand Am 1999, 2000, 2001, 2002, 2003, 2004 and 2005, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.

Where can I buy a fuel pump relay?

At O’Reilly Auto Parts, we offer high-quality fuel pump relays. Check out our stock of fuel pump relays to find the part you need for your repair.

How to test the fuel pump in a Ford?

All vehicles now use an electrical fuel pump to deliver fuel (under high pressure) to the fuel injectors and the best way to diagnose this fuel pump is with a fuel pressure gauge. The following fuel pressure test gauge kits have the Schrader valve adapter you need to test the fuel pressure on your Ford:

How to test the fuel pump in a GM 3.8L?

In all of the GM 3.8L V6 equipped vehicles, GM was kind enough to put a Schrader valve on the fuel injector rail where you can tap into the fuel system and check its performance with a fuel pressure test gauge. A fuel pressure gauge can cost you as little as $40 (US) or as much as $200 (US).

How can I tell if my fuel pump is failing?

Check the fuel pump fuse. Often, it’s not the pump itself that fails to function, but the power that supplies it. Check in your owner’s manual for the location of the fuse box, then find the fuse that corresponds to the fuel pump. Pull it out and inspect it for signs of failure.

How do you test a GM fuel pump?

GM has made it super easy for you and me to test the fuel pump (with a fuel pressure gauge), since they have installed a fitting (called the Schrader valve) on the fuel pressure regulator to which you and I can connect the fuel pressure gauge to (see photo above).

What are the symptoms of a bad fuel pump?

Symptoms Of A Bad Fuel Pump. Which And Where To Buy A Fuel Pressure Gauge. FUEL PUMP TEST 1: Fuel Pressure Test With Gauge. FUEL PUMP TEST 2: Using Starting Fluid. More 3.8L V6 GM Tutorials. You can find this tutorial in Spanish here: Cómo Probar La Bomba de Combustible (GM 3.8L) (at: autotecnico-online.com ).

How can I tell if my car has a 12 Volt fuel pump?

You can accomplish this by locating the wire (circuit) that feeds power (12 Volts) to the fuel pump and with a multimeter in Volts DC Mode, verifying that 12 Volts are reaching the fuel pump when you crank the engine. CASE 2: The engine did not start, not even momentarily.

Do you need a fuel pump pressure gauge?

Owning a fuel pressure gauge is now becoming a must. All vehicles now use an electrical fuel pump to deliver fuel (under high pressure) to the fuel injectors and the best way to diagnose this fuel pump is with a fuel pressure gauge.

Where is the fuel pump on a Pontiac Grand Am?