How to design balance shaft timing gear alignment?

1. Install the balance shaft drive sprocket. 2. For the 1st design balance chain, install the balance shaft drive chain with the colored links lined up with the marks on the balance shaft drive sprockets and the crankshaft sprocket. There are three colored links on the chain. Two links are of matching colors, and one link is of a unique color.

How to reset timing chain tensioner on balance shaft?

• Reset the timing chain tensioner by performing the following steps: • Rotate the tensioner plunger 90 degrees in its bore and compress the plunger. •Rotate the tensioner back to the original 12 o’clock position and insert a paper clip through the hole in the plunger body and into the hole in the tensioner plunger.

Is there a timing drive replacement for GM Ecotec?

This video covers the timing drive system replacement for GM’s Ecotec platform which includes 2.0L, 2.2L, & 2.4L displacement engines.

How much does it cost to replace timing chain?

Cost of parts: Timing kit $129.53, timing cover gasket $23.86, crank bolt $7, valve cover gasket, if needed, $25.27 1) Disconnect the battery. Safety first. 2) Remove two 10mm nuts mounted on studs in the driver’s side of the valve cover.

How to replace the timing chain on a GM Ecotec engine?

Parts: Timing chain kit (Cloyes 9-4201S), timing cover gasket (Fel-Pro TCS46041), crank pulley bolt, valve cover gasket set (Fel-Pro VS50596R), if needed. Cost of parts: Timing kit $129.53, timing cover gasket $23.86, crank bolt $7, valve cover gasket, if needed, $25.27 1) Disconnect the battery.

What’s the best way to change a timing chain?

Remove the bolt and washer in the center of the pulley. Put the bolt partially back in the bolt hole and use a harmonic balancer removal tool. The tool should not be a jaw type tool, but instead should apply all of the removal force to the center of the assembly. This protects the rubber ring in the harmonic balancer.

What are the bright links on a timing chain?

Locate marks or “bright” links in your timing chain. These links are brighter than the other links and are used to align your engine. Set your engine to top dead center. To get your engine to top dead center, line the bright links on the timing chain up with the marks on your camshaft and crankshaft gears.

What happens if the balance shaft is not timed?

Important: If the balance shafts are not properly timed to the engine, the engine may vibrate or make noise. There are two possible chain configurations for these engines. Both configurations use a unique chain link to line up with the intake side balance shaft sprocket timing mark. The first design uses a unique link color (1).

What to do with timing belt on accord?

With the balance belt out of the way, loosen the just-installed bolt. Move the tensioner to release tension and snug the bolt. With the belt removed, check or replace the seals and water pump and install a seal retainer. Installing a retainer plate holds the balance shaft seal in place.

How to reset the balance shaft chain tensioner?

• Install the upper and small balance shaft drive chain guides and bolts and tighten to 106 IN/LBS (12 Nm). • Install the adjustable balance shaft chain guide and bolt and tighten to 89 IN/LBS (10 Nm). • Reset the timing chain tensioner by performing the following steps:

How to design balance shaft timing gear alignment?