How do you turn off the check engine light on a 2010 Jeep Wrangler?
How do you turn off the check engine light on a 2010 Jeep Wrangler?
Put the key in the ignition and turn it to the “On” position for about five seconds. Turn the engine on. The engine warning light will flash and then turn off.
How to check engine code on Jeep Wrangler?
For JK Wranglers, checking the engine code is a relatively simple task. Just complete the following steps: Insert key into the ignition. Turn to “ON” position without starting the Jeep. Push the key in and turn it to “OFF” and then to “ON” three times, leaving it in the “ON” position.
What to do if Jeep Wrangler has not logged in DTC?
If your Jeep JK Wrangler has not logged in any DTC’s, the dashes on your odometer will be followed by the message ‘-done-‘. Turn your key to the ‘OFF’ position and you will in fact be done.
Where do the check engine lights go on a Jeep Wrangler?
Don’t go too slow, or it may not register. Once those steps are completed, all lights on the dash should turn on and six dashes should appear in your odometer. If your Wrangler has logged any check engine codes, they will display after the dashes refresh. The message “Done” will appear if your Jeep hasn’t logged any codes.
What is the DTC code for a JK Wrangler?
Wrangler DTC codes can range from low battery voltage to sensor issues, depicted by a string of digits. For JK Wranglers, checking the engine code is a relatively simple task.
For JK Wranglers, checking the engine code is a relatively simple task. Just complete the following steps: Insert key into the ignition. Turn to “ON” position without starting the Jeep. Push the key in and turn it to “OFF” and then to “ON” three times, leaving it in the “ON” position.
Why does the Check Engine light come on on a Jeep Wrangler?
Sometimes the Wrangler check engine light can illuminate after installing an aftermarket modification. When the engine light comes on, there are several ways that you can check to see what’s wrong.
If your Jeep JK Wrangler has not logged in any DTC’s, the dashes on your odometer will be followed by the message ‘-done-‘. Turn your key to the ‘OFF’ position and you will in fact be done.
Wrangler DTC codes can range from low battery voltage to sensor issues, depicted by a string of digits. For JK Wranglers, checking the engine code is a relatively simple task.
