Where is the diesel particulate sensor located?

Where is the diesel particulate sensor located?

engine compartment
The DPF differential pressure sensor is usually mounted in the engine compartment to protect it from heat. The sensor is connected to the engine control unit (ECU) by an electrical connector and connected to the DPF via two silicon hoses.

What causes an engine to have a p242f code?

The conditions for causing the code P242F to be stored may cause internal engine or fuel system damage and should be addressed with haste. Symptoms of a P242F code may include: Excessive black smoke from the exhaust Possible causes for this engine code include: Excessive ash accumulation in the DPF Clogged DPF pressure sensor tubes/hoses

What does p242f mean in diesel particulate filter?

Although generic, the specific repair steps may vary depending on make/model. On rare occasions, when I have discovered a stored P242F code, it has meant that the powertrain control module (PCM) has detected a level of ash restriction in the diesel particulate filter (DPF) deemed to be restrictive.

What are the symptoms of a p242f filter restriction?

Symptoms of a P242F code may include: 1 Diminished engine performance 2 Excessive black smoke from the exhaust 3 Higher engine temperatures 4 Higher transmission temperatures

Is there a p24ae code on my Jeep?

They said that they would have to put their own code reader on the Jeep even though I told them that my friend, which is an ASE Certified Master Mechanic of over 25 years did so for me as a favor. I waited for over 2 hours, then the lady from the service dept cam and told me that yes indeed, the P24AE code did pop up.

What does the particulate sensor on a jeep do?

If you think about it that sensor I believe is supposed to measure the amount of particulate in the tank. If it doesn’t change which with no sensor input it should not there should be no issue with driving it as long as the tank doesn’t fill up. City driving I think might be concerned but my driving is 70% hiway.

What are the symptoms of a p242f engine code?

The conditions for causing the code P242F to be stored may cause internal engine or fuel system damage and should be addressed with haste. Symptoms of a P242F code may include: Diminished engine performance. Excessive black smoke from the exhaust. Higher engine temperatures.

What is the diagnostic code for a jeep check engine light?

Refer to our Generic OBD II code list for definitions on all other Jeep diagnostic trouble codes. Manufacturer Specific Codes P1105Open Or Shorted Condition Detected In The Baro Read Solenoid Control Circuit – Read Our Article on Automotive Circuit TestingFor Help With This Jeep Check Engine Light Code P1192Inlet Air Temp. Circuit Low