Is there a problem with the exhaust manifold on a Dodge Ram?

Broken exhaust manifolds bolts have become a common problem on 4th generation Dodge Rams. Dodge has improved on the bolts design, and owners are suggested to repair the problem before the bolts break. Otherwise, expensive bolt extraction and thread repair may be needed.

How do you replace the exhaust pipe in a Dodge Ram?

From the underside of the truck, remove the bolts and nuts that attach the exhaust pipe to the exhaust manifold. Lower the truck to the ground. Remove the four nuts from the heat shield and remove the shield. Note which manifold bolt positions have the threaded studs so you can put them back in the same positions during reassembly.

How much does it cost to fix a Dodge exhaust manifold?

The repair can be from $200 to $400 or more depending on whether the manifold and gaskets are also replaced. Dodge now installs new stainless steel bolts/studs (part number 6509544AA), which has proven somewhat successful permanently fixing the problem. Some owners still post about their second trip to the dealer for the same fix.

How do you install a new exhaust manifold?

Remove the manifold bolts and remove the manifold and manifold gaskets. Discard the gaskets. Inspect the mating surfaces and scrap as needed to make a smooth, clean face for the new gaskets. Position the exhaust manifold gasket and install the manifold.

How to replace the exhaust manifold on a Dodge Ram?

Soak the bolts with penetrating oil overnight. Use a torch to expand and soften up the metals before removal. Remove the wheel/fender liners for the best access to the exhaust manifolds. If the manifolds are removed, replace the gasket. Figure 2. Using a bolt extraction tool. How Do I Know Whether I Need to Replace the Exhaust Manifolds or Not?

What to do if you have an exhaust manifold issue?

Be prepared with the proper thread repair and bolt extraction tools. Soak the bolts with penetrating oil overnight. Use a torch to expand and soften up the metals before removal. Remove the wheel/fender liners for the best access to the exhaust manifolds. If the manifolds are removed, replace the gasket.

How much does it cost to replace exhaust manifold bolts?

Discussion in ‘ Engine & Performance ‘ started by 2010 Infantry Vet, Nov 14, 2018 . Ok so im installing my JBA long tubes this weekend, and have 4 broken factory exhaust manifold bolts. I ordered the dorman that are suppose to be grade 10.9 Also ordered $39.

What kind of bolts do I need for exhaust manifold?

Stock type bolts are not going to work with headers. ARP makes a good product and should be good to go. huntergreen, Tach_tech and Bee1971 like this. What’s your plan for removing the broken studs?

When did the 6.7 Cummins exhaust system come out?

With the release of the 6.7L Cummins in 2007.5 model year applications came an entirely new exhaust system for the Rams. This factory system features a 4″ turbo back exhaust that features a catalytic read more With the release of the 6.7L Cummins in 2007.5 model year applications came an entirely new exhaust system for the Rams.

Is the Dodge Ram losing boost and exhaust brake?

Started it back up and light had cleared, and drove fine back to camp. Today, the CEL comes back on. I noticed the truck is wanting to downshift a lot, which is unusual. Turbo was putting out very little boost, a range of about 1-12 lbs.

What are the brakes on a ram 6.7 Cummins?

The PRXB exhaust brake from PacBrake provides stopping power to not only save your service brakes, but keep you and your load safe on nasty descents. PacBrake C11745 PacPro Foot Switch Kit PB-C11745 1.00 PacBrake C11745 Leave your hands to the driving with this universal foot switch.

How big is the intake manifold on a Dodge 4.7L?

You can’t post conmments that contain an email address. For 1988-1995 4.3L,5.0L and 5.7L intake manifold bolts are torqued to 35ft.lbs.Start with center bolts on each side moving out finishing with the bolts in the front of the motor and the back You can’t post conmments that contain an email address.

How much does it cost to replace exhaust manifold in Dodge Dakota?

received a Exhaust Manifold Replacement. Dodge Dakota Exhaust Manifold Repair costs $357 on average. What is the Exhaust Manifold all about? Depending on your engine and type of vehicle, the exhaust manifold can either be a set of pipes or it can be a cast iron manifold assembly.

How much torque does an exhaust manifold have?

Discussion in ‘ Engine & Performance ‘ started by kg93, Oct 27, 2015 . Just needed a quick answer as to what the header bolts are supposed to be torqued at? in the ” hemi torque specs” at the top of this forum page it says 23foot pounds.

What happens if you have a bad intake manifold?

If the intake manifold gaskets leak coolant into the intake manifold the engine may overheat as a result, without any visible external leaks. Any coolant leaks should be addressed as soon as possible to prevent the possibility of serious engine damage occurring due to a bad intake manifold gasket.

Is there a problem with my Ram 1500?

Multiple coolant leaks are one of the more common 2015 RAM 1500 problems, as well as affecting model years 2009-2014. Many owners report that the leaking is strange because it’s difficult to locate even with a pressure test and that the leak only occurs when the engine is cold.

Can a leak in the intake manifold cause a bad smell?

Some intake manifold gaskets also seal engine coolant, and if the gasket wears out it may lead to a coolant leak. This may produce a distinct coolant smell, along with steam, and drips or puddles of coolant underneath the vehicle. Coolant leaks should be addressed as soon as possible, in order to prevent them from becoming a greater issue. 3.

How to fix exhaust manifold leak in Dodge Ram?

At least you can get free labor. huntergreen likes this. Have them pull the manifolds and have them mill them. They should be done flexing. Or buy some headers and have them install headers. Pull Ya and tidefan1967 like this. truck has only 45000 miles on it and leak goes away after about ten minutes .

Can a Ram 1500 exhaust manifold be replaced?

Rep said , no need to waste 700 to 800 dollars on it but its under warranty still. Really disappointed in the Ram 1500 Right now ……. Click to expand… I never heard dealer replace the manifolds. The proper way to do it is to resurface the manifolds so they’re not warped and replace all bolts.

What are the symptoms of a broken manifold on a 5.7 Hemi?

5.7L HEMI Exhaust Manifold Bolt Failure Symptoms The primary symptom of broken exhaust manifold bolts is the ticking noise. Broken manifold bolts on the HEMI 345 create an exhaust leak. If it’s bad enough then you may notice power loss.

What to do if exhaust manifold bolt breaks?

An alternate method is completed by threading the bolt with a dye and hot welding or cold welding (J-B Weld) a nut to the bolt. You can then turn it with a normal socket or wrench. If the bolt breaks where it meets the cylinder head, you still have options. A bolt extractor can be used that works itself into the bolt, making it possible to turn.

Are there any broken bolts on a Dodge Ram?

No real photos as subject matter has been covered. Two broken bolts (rear), snapped off at the head, drilled and spun out with left hand bit. Had to purchase a close quarters or right angle drill but no worries, it worked. Truck is at 138k.

Why are the gaskets on my Dodge Dakota breaking?

BOTH GASKETS LEAK AND BOLTS BROKEN REQUIRES LIFTING ENTIRE ENGINE AWAY MOTOR MOUNTS HUGE REPAIR BILL I HAVE SPENT OVER 3000 DOLLARS TO KEEP THIS TRUCK ON THE ROAD ALL DUE TO MANUFACTURER CAUSED PROBLEMS. Clicking, rapid and sharp, coming from the exhaust manifold region of my 3.9 v6 engine in my 2003 Dodge Dakota SXT 4×4 automatic pick up truck.

How much does it cost to replace an exhaust manifold in a Dodge Dakota?

The average cost for a Dodge Dakota Exhaust Manifold Gasket Replacement is between $196 -$238. Learn More Good news! We found 32 RepairPal Certified shops near you.

Is there a recall on Dodge Dakota exhaust?

The dealer seems to be aware that it is a common problem on Dakotas. This should be a recall due to health hazards and possible fatalities it causes to all passengers and driver breathing in exhaust fumes. This is the result of either poor engineering or poor compatibility of metals used.

The average cost for a Dodge Dakota Exhaust Manifold Gasket Replacement is between $196 -$238. Learn More Good news! We found 32 RepairPal Certified shops near you.

Is the exhaust manifold on my Dodge 4.7 bad?

Upon doing a little research, I learned that the 4.7 has a very bad design for its exhaust manifold. So, early on sat morning, I went to the local Dodge dealer and purchased a complete set of new bolts and a gasket which ran me $37.20 for everything.

Why is the freeze plug on my Dodge Ram rusting?

Using tap water instead of distilled in your radiator will also cause more rusting because of the minerals in tap water. These things combined with a general consensus that the early generation Dodge RAM trucks used a rather poor quality freeze plug that was prone to rusting.

Why is the coolant leaking from my Dodge Ram?

Do not neglect having the radiator flushed at the regular interval. The radiator fluid has rust inhibitors that will eventually break down over time, and as a result, things such as the freeze plugs will rust out and cause a leak.

When does exhaust manifold leak in Dodge truck go away?

Discussion in ‘ Engine & Performance ‘ started by mario mejia, Nov 29, 2018 . Multiple votes are allowed. truck has only 45000 miles on it and leak goes away after about ten minutes .

Where can I get a Dodge exhaust manifold kit?

Whether you’re a do-it-yourselfer or trained auto tech, you’ll appreciate the convenience of home or business delivery, or picking up your Exhaust Manifold Hardware Kit product at the nearest Advance Auto Parts location. Search our full catalog of aftermarket Dodge Exhaust Manifold Hardware Kit products below.

Stock type bolts are not going to work with headers. ARP makes a good product and should be good to go. huntergreen, Tach_tech and Bee1971 like this. What’s your plan for removing the broken studs?

How big should the head of an exhaust manifold be?

Do not use unless you enjoy drilling and tapping to remove and replace. Our Exhaust Manifold Hardware Kit provides you with the proper studs, bolts, and nuts for replacing your manifold. Save time and energy by having the right hardware on hand when you need it. Fit great, head size is 12mm instead of 13mm.

How many exhaust manifold bolts are in a Dodge Ram?

Ok so im installing my JBA long tubes this weekend, and have 4 broken factory exhaust manifold bolts. I ordered the dorman that are suppose to be grade 10.9

How much does it cost to repair exhaust manifold on Dodge Ram?

Owners with 2010 and newer trucks typically have warranties that run out after 5 years/100,000 miles. The repair can be from $200 to $400 or more depending on whether the manifold and gaskets are also replaced.

Are there any recalls on Dodge Ram manifold bolts?

Recall on manifold bolts – I know it’s a common (and known) issue on our Hemis but never heard of a recall addressing the bolts. I’m lucky so far, but already out of warranty @ 35k Miles.

What’s the part number on the Dodge Ram?

Dodge now installs new stainless steel bolts/studs (part number 6509544AA), which has proven somewhat successful permanently fixing the problem. Some owners still post about their second trip to the dealer for the same fix.

Recall on manifold bolts – I know it’s a common (and known) issue on our Hemis but never heard of a recall addressing the bolts. I’m lucky so far, but already out of warranty @ 35k Miles.

Are there any recalls on exhaust manifold bolts?

Last year I received a letter stating that the exhaust manifold bolts were under recall, so I had the work performed. At the time most of them were needing replaced, truck sounded horrible at start up.

Is there a recall on Hemi manifold bolts?

Haven’t heard of the recall on this either. Never been a recall on hemi manifold bolts, I work for a Chrysler dealership here in Alberta. Just a known issue that’s usually replaced under warranty 90% of the time. madtrucker2016, Blackdodge2010 and tidefan1967 like this.

What happens when the tipm goes out on a Dodge Ram?

When the TIPM starts to go out: Airbags may not deploy in a crash and/or may deploy at random. The horn may go off at random. Power windows will stop working or start opening themselves. The fuel pump may not shut off when the vehicle does. The starter may crank, but the truck won’t start.

Is there a problem with the exhaust manifold on a Dodge Ram?