How do you reset the anti theft system on a chevy Suburban?

How do you reset the anti theft system on a chevy Suburban?

How to Reset the Passlock System on GM Cars

1. Insert your key in the starter, start you car as you usually would and let it stall. Keep the key in the “On” position.
2. Wait until the “Theft Sys” light on your dashboard stays on without blinking. This will take approximately 10 to 15 minutes.

How do you reset the 2002 chevy Suburban?

To reset this system, put Your key in the ignition and turn it to the ON position, but don’t start the engine. Let the vehicle sit for about 10 minutes, just leaving it there in the ON position. After the ten minutes, try starting Your vehicle. If it starts, then You know there was an issue with the Passlock system.

How do you reset a chevy theft deterrent?

The anti-theft is now reset. In a chevy silverado, you will try to reset the anti-theft system by turning the key on until the yellow lock goes out on the instrument panel for about 10 minutes. Turn the key off and do it 2 more times after 3 cycles, pull the key and put it back in.

How do you reset a Chevy Silverado after changing the battery?

Chevrolet Silverado 1500 Questions – How do you reset a chevy silverado after changing the battery? – CarGurus How do you reset a chevy silverado after changing the battery? The horn sounds, the flashers are on, the wipers and washers are on and the hich beams are on? How do you reset the system when this happens? Next time use a code saver.

What to do if your car alarm starts when you turn it on?

Fix an alarm that starts when you turn the car on. You could need a new battery. Disable the alarm by removing the alarm fuse, and then bring the car to the shop. They can check your battery and move on from there if the problem is the alarm system.

How can I disable the alarm system on a 1997 Jeep Grand?

If there is the Honda added security box installed at the lower left side of the kick panel turn the ignition key to the on position. Locate the small button on the box and hold it down for 90 seconds and the alarm will bypass. Call to the dealer, this was their response: With the ignition key try to start the vehicle.

How long does it take to turn off a GM security light?

Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops flashing. 2. Turn the ignition switch to the “OFF” position for 30 seconds. 3.

Chevrolet Silverado 1500 Questions – How do you reset a chevy silverado after changing the battery? – CarGurus How do you reset a chevy silverado after changing the battery? The horn sounds, the flashers are on, the wipers and washers are on and the hich beams are on? How do you reset the system when this happens? Next time use a code saver.

If there is the Honda added security box installed at the lower left side of the kick panel turn the ignition key to the on position. Locate the small button on the box and hold it down for 90 seconds and the alarm will bypass. Call to the dealer, this was their response: With the ignition key try to start the vehicle.

Fix an alarm that starts when you turn the car on. You could need a new battery. Disable the alarm by removing the alarm fuse, and then bring the car to the shop. They can check your battery and move on from there if the problem is the alarm system.

Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops flashing. 2. Turn the ignition switch to the “OFF” position for 30 seconds. 3.