Can a bad ignition switch keep a Jeep Wrangler from starting?
Can a bad ignition switch keep a Jeep Wrangler from starting?
And, it can keep your Wrangler from starting in a couple of different ways. The first is when the starter cranks, but the bad ignition switch doesn’t turn on the fuel pump or ignition. The engine will just turn over with no spark. The second way is when the starter doesn’t turn at all.
What to do if your Jeep Wrangler won’t start?
Turn the key enough to move from park to neutral. Hold your foot on the brake while turning the key to start the ignition. If your Jeep won’t start and you simply hear one click, then you could have a faulty starter motor. Again, using a voltmeter with a load function, make sure all your voltages are all correct.
Where is the starter relay on a Jeep Wrangler?
There is a small “Starter Relay” inside that should cllick softly when you turn the ignition key to Start. That Starter Relay in turn energizes the big starter relay located on the starter motor where the engine bolts to the transmission, underneath.
What are the symptoms of a bad ignition switch?
The most noticeable symptom of a bad ignition switch is stalling. Your Wrangler stalls because the faulty switch turns off the fuel pump or power to the ignition. When this happens, the engine will not be able to run until it gets that signal back. 2.
And, it can keep your Wrangler from starting in a couple of different ways. The first is when the starter cranks, but the bad ignition switch doesn’t turn on the fuel pump or ignition. The engine will just turn over with no spark. The second way is when the starter doesn’t turn at all.
Turn the key enough to move from park to neutral. Hold your foot on the brake while turning the key to start the ignition. If your Jeep won’t start and you simply hear one click, then you could have a faulty starter motor. Again, using a voltmeter with a load function, make sure all your voltages are all correct.
There is a small “Starter Relay” inside that should cllick softly when you turn the ignition key to Start. That Starter Relay in turn energizes the big starter relay located on the starter motor where the engine bolts to the transmission, underneath.
What kind of Jeep Wrangler wont turn over?
Enter your ride HERE to be a part of MAY’s Ride of the Month Challenge! I have a 92 wrangler 4.0 6cyl with 5 speed, 200,000 miles on it and it just died. I have no electrical, wont turn over, no lights.
