Where are the wires for the remote starter?
Where are the wires for the remote starter?
In this car it is the RED and ORANGE wires in the middle of the connector jack to the key switch. The key must be inserted to find the other 4 wires. Turning to the Accessories position, testing with my multimeter gives the YELLOW wire.
How do you connect a remote starter to a parking light?
Connect these wires to the parking light and brake output wires on the remote starter. To find the brake wire press the brake pedal down while the car is on and use the multimeter to test the wire.
What’s the best way to test a remote starter?
A digital multimeter is recommended for testing during and after installation. Some remote starters will come with all the necessary tools so check your box. For example, many systems come with an LED circuit tester to find the necessary wires for installation. It is recommended that you solder all your wires together to form better connections.
Where is the kick Panel on a remote starter?
If you choose to connect your remote starter to other functions such as the door locks and overhead lights then you will need to remove the kick panel as well. This is located on the lower left-hand corner of the driver’s foot box. Connect all your wires properly. It is very important that you securely connect all your wires.
In this car it is the RED and ORANGE wires in the middle of the connector jack to the key switch. The key must be inserted to find the other 4 wires. Turning to the Accessories position, testing with my multimeter gives the YELLOW wire.
Where is the Avital remote starter wire located?
The avital purple ties to the other end of the GRAY wire running to the engine starter. This wire is at the top of the connector. The last pic shows a convenient wiring diagram I did to identify all the heavy gauge wires for the remote start module.
How do you splice a remote turn on wire?
Since the factory wire is already terminated on both ends, splicing into the wire is necessary. Use a T-tap connector or cut the factory wire to splice into the wire by twisting the remote turn on wire together with one end of the factory wire, then crimp on a butt connector.
How do you tap into an existing wire?
To tap into an existing wire with a connector, simply cut the cable where it needs to be spliced. Strip both ends as well as the end of the new cable you want to add. Place a wire nut of the appropriate size onto the three cables. Twist the wire nut in place and ensure that the wires are not coming out.
Where can I get a remote starter in PA?
Enormis Mobile Specialties in Erie, Pennsylvania, has been specializing in remote starters since our inception in 1999. Over the years, Enormis has installed thousands and thousands of remote starters and has built a loyal following in northern Pennsylvania.
What does 12volt mean on Hyundai remote starter?
Retard inbred Hyundai engineers uses 12volt only when the key is at the ON position. The remote start module refuses to start if the black/white safety wire is not already at 0volt. Luckily my wife has not yet gone the way of her mother by turning off her car in gear complete with keys and door wide open.
