What do I need to install a stereo in a Dodge Ram?
What do I need to install a stereo in a Dodge Ram?
Tools needed: Phillips screwdriver, small flat blade screwdriver, Torx T-20 driver, panel tool, 7mm socket, rachet and extension, shop rag, hacksaw or Dremel tool (double-DIN only) It’s relatively easy to retain the steering wheel audio controls when you install a new stereo in your Dodge Ram.
How many speakers does a Dodge Ram have?
If your truck has a column shifter, radio replacement is a reasonably easy job (Crutchfield Research Photo) The Ram’s base system was a perfectly acceptable AM/FM/CD/AUX receiver with six speakers.
How to replace dash speaker in Dodge Ram?
The Alpine center dash speaker is easy to remove and replace (Crutchfield Research Photo) The center dash speaker in Alpine-equipped trucks are 3-1/2″ models that are quite easy to remove and replace. Use a panel tool to pry up the speaker grille and release four clips. Lift the grille, disconnect the sensor wiring harness, and remove the grille.
How tall does a double DIN receiver need to be in a Dodge truck?
The (slightly) challenging part comes if you install a double-DIN receiver in any of these trucks, because you’ll need to do a little trimming inside the cavity to allow for the new stereo’s extra chassis height. Approximately 1/4″ of the plastic sub-dash and approximately 3/8″ of the metal sub-dash support will need to go.
Tools needed: Phillips screwdriver, small flat blade screwdriver, Torx T-20 driver, panel tool, 7mm socket, rachet and extension, shop rag, hacksaw or Dremel tool (double-DIN only) It’s relatively easy to retain the steering wheel audio controls when you install a new stereo in your Dodge Ram.
Where was the 2010 Dodge Ram 2500 purchased?
Purchased on 08/12/10 and owned in AB until 06/02/21. Driven an estimated 12,753 miles/year. Accident reported: minor to moderate damage. Purchased on 07/31/10 and owned in FL until 11/29/12. Driven an estimated 20,311 miles/year. Last serviced at 142,928 miles in Apopka, FL on 03/11/21 • Vehicl… No accident or damage reported to CARFAX.
If your truck has a column shifter, radio replacement is a reasonably easy job (Crutchfield Research Photo) The Ram’s base system was a perfectly acceptable AM/FM/CD/AUX receiver with six speakers.
The Alpine center dash speaker is easy to remove and replace (Crutchfield Research Photo) The center dash speaker in Alpine-equipped trucks are 3-1/2″ models that are quite easy to remove and replace. Use a panel tool to pry up the speaker grille and release four clips. Lift the grille, disconnect the sensor wiring harness, and remove the grille.
