How do you reset the check engine light on a 2009 Dodge Caravan?
How do you reset the check engine light on a 2009 Dodge Caravan?
How Do I Reset the Check Engine Light on a Dodge Grand Caravan?
- Turn off your ignition.
- Put on a pair of safety gloves and glasses.
- Find your battery’s negative terminal.
- Loosen the nut on the negative terminal with a wrench.
- Pull the negative connector from the battery and set it aside for 30-60 seconds.
Why is the Check Engine light on on my Ram 1500?
One simple reason is that your gas cap isn’t secured tightly in place, or your RAM 1500 has a dysfunctional solenoid (the component connecting the car battery to the ignition switch). In any case, if your RAM 1500’s check engine light is on, you don’t want to just reset it. You’ll want to first determine what’s going on.
Where to find check engine light codes on Dodge?
These are listed in numerical order for easy searching. When retrieving Dodge check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located near the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
Why does my check engine light keep coming on?
This is the most common reason a check engine light comes on. It’s an easy fix, too. Simply access the gas cap, remove it, and replace it. Then make sure it’s seated in place. Follow these easy steps to resetting your check engine light, and you should be good as gold.
How to reset PCM and check engine light in Dodge Ram?
The reset procedure in your Dodge Ram is as easy as they come. First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch on the front of the hood to open it. Find the power distribution center (PDC); it will be a black box near the battery. Unlatch and open the cover of the PDC.
What is the diagnostic code for a Dodge check engine light?
Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s). Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Dodge diagnostic trouble codes. Manufacturer Specific Codes P0138HO2S12 High Voltage – Related Information
One simple reason is that your gas cap isn’t secured tightly in place, or your RAM 1500 has a dysfunctional solenoid (the component connecting the car battery to the ignition switch). In any case, if your RAM 1500’s check engine light is on, you don’t want to just reset it. You’ll want to first determine what’s going on.
What to do when your check engine light comes on?
There is no need to panic when your check engine light comes on. You can simply check your list of codes, take care of the issue yourself or seek help, or reset the check engine light and be on your way. It’s that simple. This article applies to the Dodge Ram (2009-present).
What does gas cap light and check engine light come on?
Ok- The P0457 does point to a loose/faulty fuel cap, however, it is diagnosed as an “EVAP System Large Leak Detected” – so- make sure the fuel cap you replaced the old one with meets or exceeds Dodge specs (for example, if you bought a replacement cap from AutoZone, it’s far BELOW Dodge specs, and will NOT seal the system).
