How do you get obd2 ready?

To determine if readiness OBD II monitors are complete:

Turn the ignition key to the “on” position for 15 seconds without cranking the engine.
If the “Service Engine Soon” light blinks eight times, one or more readiness monitors are incomplete.

What’s the drive cycle procedure for a Dodge?

– Fuel level is between 30 & 85 % full. 1) Cold soak vehicle, start and idle vehicle for 4 minutes. 2) Drive in-town (stop and go) for 5 minutes, using smooth accelerations and decelerations. 3) Stop and idle vehicle for 4 minutes.

How long does a drive cycle take on a Dodge Dakota?

2) Drive (with steady throttle) at a speed between 40 and 60 mph for 8 minutes. 3) Stop and idle for 3 minutes. 4) Drive (with steady throttle) at a speed above 20 mph for 2 minutes. 5) Turn key off, leave off for ten minutes (to run O2 sensor heater monitor).

How long does a Chrysler Drive Cycle take?

How to do a closed loop drive cycle?

1) Idle vehicle for five minutes (to reach closed loop operation). 2) Drive with a steady vehicle speed above 25 mph for 2 minutes. 3) Stop and idle for 30 seconds. 5) Repeat steps 3 & 4 five (5) times.

How do you perform a basic drive cycle?

Here are step-by-step instructions on how to perform a basic, yet very effective, drive cycle that will complete the readiness monitors for your vehicle’s emissions control system. Have the fuel tank between 30 and 70 percent full. Some systems, especially the EVAP system, need to have a specific level of fuel in order for the tests to be trusted.

How long does a drive cycle take in a Chrysler?

For all drive cycles, make sure the check engine light (MIL) is off. Smoothly acceerate and maintain a speed between 40 to 60 mph for 8 minutes. Stop and idle for 3 minutes. Smoothly accelerate and maintain a speed above 20 mph for 2 minutes.

How do you get obd2 ready?